NW guys- two swap meets this weekend... Who's going?

This weekend we have two swap meets! Saturday is the Tri City's swap in Kennewick, and Sunday is the small Wandermere swap meet in Spokane. Both are on the smaller side, but always a good meet. Anyone around here going? I'll have a booth at both

 

Anyone??

 

where's the one at in spokane? i might have to head over and check it out.

 

going to tri-city will look you up...Dave

 

Hummm.... I missed opening day of fishing to go to the Winfield cl***. The wife was ok with that, but If I don't take her fishing sunday.........

 

Chris,

I will probably stop and say Hi up at Wandermere on Sunday

 

i'd like to go to Kennewick, but i just dropped a bunch on a desoto motor. Going to a good swap meet with no money is about as much fun as going to a good *****house for the ambiance...

 

Wandermere mall parking lot, in North Spokane. Right on Hwy 395 just past the "Y"

 

Btt

 

I'll be at the Street Tin swap at Wandermere. My parents are in the host club and will be working, so my daughter and I will be there for a few hours.

 

Ill be at the kennewick meet, hope theres a little more stuff then last year, at least this year I know better than to walk by a table of 97s without buying them!

 

Im loaded and ready, see whoever is going to Tri Citys in the morning

 

I'll probably try to make a quick run to Tri-Cities right after I get off work at 11 and see if I can find any last minute bargains and Jean has wanted to go for a ride anyhow. Last week took most of my spending money though.

 

Was looking forward to both....but stuck working now inspecting jets all weekend.

 

We bailed out of here right after 12:00 and got down there about 1:30 I could have spent a pot load of money if I had it on me and had a way to haul a couple of bed sides home. One guy had pretty nice bed sides and tail gate for my 48 and another had an Offy four barrel intake Holley carb and headers that would fit my 292 and I didn't have much cash on me. I did get a dash for my roadster and a front spring for a Model A axle I have stashed back. I raced off without either camera so no photos this time.

 

I was dissapointed, no gee-gaw customizing pieces.

 

Chris, I just missed you but I scored some nice bumpers and an invitation from a guy to come and paw through some 34 Ford parts he has been ratholing. It sure pays to chat the guys up in the crowd.