Projects 64 dart ft altered wheel base

Not much new with this project. I have to find a shop
Posted using the Full Custom H.A.M.B. App!

 

Put the dart back in garage it won't leave till done. .started to da body today

Posted using the Full Custom H.A.M.B. App!

 

Posted using the Full Custom H.A.M.B. App!

 

Hope to have it done by eagle field in Feb.

Posted using the Full Custom H.A.M.B. App!

 

Pulling motor tomorrow to reseal it then wire it up. And start building fender well headers

Posted using the Full Custom H.A.M.B. App!

 

Posted using the Full Custom H.A.M.B. App!

 

bad ass!!!

 

Motor is ready to go in then make my headers

Posted using the Full Custom H.A.M.B. App!

 

Very cool build! Hope you make it by Feb., but there's always May if you don't!

 

See you there in Feb.! VERY tasty how you set that up, just right. What did you use for a front axle?
(tube type & size, wall thickness)

 

I used a 64 dodge a 100 front end. Cut it down 5 1/2 inches
Posted using the Full Custom H.A.M.B. App!

 

Got my front wheel wells done today I didn't like the cut off look so made some bends and stretched. A shrink till the front section looked good

Posted using the Full Custom H.A.M.B. App!

Got

 

Posted using the Full Custom H.A.M.B. App!

 

Motor is in

Posted using the Full Custom H.A.M.B. App!

 

Posted using the Full Custom H.A.M.B. App!

 

Now have to figure out how to hook up master cylinder

Posted using the Full Custom H.A.M.B. App!

 

Nice project. The fender looks good. How tuff was it to move the rear?

 

http://arengineering.com/products/offset-mc-adapterhemi-a-body-2-stud-mc/

 

I'm really liking this build, BTW, is that dually your tow vehicle???

 

I figured somebody made an offset adaptor.

 

It's another project I been working on.36 mack cab on homemade frame

Posted using the Full Custom H.A.M.B. App!

 

Thanks for the info on the master cylinder adapter
Posted using the Full Custom H.A.M.B. App!

 

Posted using the Full Custom H.A.M.B. App!

 

It was a lot of measuring and work but isn't to bad. Then the guts it took to make the first cut

Posted using the Full Custom H.A.M.B. App!

 

I was gonna use it for tow.it's a 36 mack truck cab

Posted using the Full Custom H.A.M.B. App!

 

excellent project..you are helping me make up my mind about putting an dropped axle under my 63 tempest a/fx-er..it cheaper than a stock front rebuild and disc brakes, plus looks stoopid cool..heck, the car never turned corners anyway, might as well look mean going straight..are ya gonna build zoomies for the dart?..

 

I was thinking on zoomies don't know yet

Posted using the Full Custom H.A.M.B. App!

 

Quarter panel ruffed in now have to do drivers side.dang back has been giving me trouble haven't done anything in awhile

Posted using the Full Custom H.A.M.B. App!

 

Have to make a new tunnel

Posted using the Full Custom H.A.M.B. App!

 

Would it be too much hassle to do an under-dash 90 degree, lay-out, like in Hot Rods??? Especially since you want to keep heat away from braking system. Checking fluid level may be a bitch. Just sayin'
Very cool Dart project. deserves a killer paint job and all lettered up.

JT

subscribed