does this look right to you

Just got a ****** adapter from a supplier. When I opened the box I noticed the one drilled and tapped hole is awfully close to the edge. Thoughts?

 

That does not look right to me. Not at all. You should have the width of the hole to the edge as a general rule as I understand it. I wouldn't run that, I'd be on the phone with the supplier.

 

Send it back.

 

+1

Posted using the Full Custom H.A.M.B. App!

 

Exactly, at least 1 hole diameter from the edge to the center of the hole, better to be 1.5 or 2 hole diameters in cast aluminum. The supplier probably just had it mounted crooked in the machining fixture. Send it back and ask for a new one.

 

yeah, quality control is now in the hands of the consumer. sad, but true.

 

If it was a single hole holding something to a chunk of aluminum I'd be concerned but seeing that it has 4 tapped holes and the transmission registers in the center I would move on. Let the seller know in case it creates a problem later.

I would, however, slip a trans on there and make sure everything lines up.

Charlie

 

Absolutely, send it back !

 

I suppose you could see whether your ****** mount holes line up with all the holes on the adapter -- my guess is it won't.
In any case I would return it.

 

Excellent advice, better to be inconvenienced by waiting for your replacement than to be inconvenienced when you're in your coveralls, under the car with the ****** out and then find out it doesn't fit (after several attempts).

 

Frozenmerc is correct send it back and ask for a discount since they inconvenienced you

 

exactly, doesnt look like it would even be able to bolt up.

 

X's 2

 

Thanks Guys......that's my opinion to. It's going BACK. Hopefully there's no h***le about shipping cost

 

I think before I sent it back I would talk to the supplier. I would also check to see if there is a reason that it needs to be that close to the edge, as in something doesn't allow it to have a larger ear there.

Does it bolt up to the transmission?

 

I wouldnt accept that for my car, even if it did fit. That looks like dimpled ***.

 

Look again, that hole is partially covered by paper

 

........Wow. You're right, It sure did look bogus at first glance.

 

So it is - Thanks. couldn't see that until I blew it up

 

Yeah, id send it back, if they tell you its good, then find another supplier, theres no strength for that thread. If its not refundable, then maybe thread a br*** bolt in there and have a good welder build up the outside, run a roll-tap into it to reform the thread, then check the faces for flatness.

the metric system? never heard of it.......

 

Not right -- give 'em a call and tell them its coming back.

 

TRUST ME, there is no PAPER, TAPE, or anything else anywhere near that hole

 

He was talking about the hole at the bottom right corner of the pic.

 

Yeah, that's the newspaper it was packed in. that hole is ok

 

Better pic

 

Again - Does it Fit the Transmission????????????????

 

****** not here yet. It's on its way (T5)

 

Before everyone gets too excited, how deep is the hole? And is it actually in the right place?

If the location is correct, can the hole be drilled/tapped deeper? If I could get 2 to 3" of thread engagement (or more) I don't think I'd be all that worried.

 

SPEEDWAY??????

 

Not Speedway. Not going to say who, till they have a chance to make good on it. Cant put it together yet anyhow...****** not here yet......and it's to damn cold in my detached garage....lol