The Jalopy Journal
What homes? You added to a ten year old post, clarify and maybe someone can help.
See post #48. My lift looks to be the same as yours, at least from picture. No issues.
1973 thats a new one!
Friends can give you bills of sale:rolleyes:
Notice the front suspension in the '64 [pic 2-3-4] version. Ford pulled that suspension [so I read] as was very wonky/dangerous and made them go...
Looks like a Possum. Caught a couple over the summer. Twas a bitch to get them out of the have a heart!
Is that an ariel square four MC?
Blaster done and tested. Very happy! Shameless plug for Tacoma Company upgrades!!
A great stability improvement. Since the bottom plates warp when welded to column they give you shims to take out any unevenness if you bolt down...
Still working on my sand blaster. All most done. Spent more money than I thought to up grade a HF cabinet blaster. Hope it works.!!
A friend had a Crescent wrench hanging on a nail on his workbench leg. Must of been near 3 feet long. I asked where the hell do you use that? He...
They say more to come..
Henway?
"" (maybe I should just stop hitting potholes, almost impossible around here)."" I can relate to that being here in CT!
I was just going to type the above! Rotate the rear axle 3° down from currant position and see what happens.
41 Fords had a panhard bar and sway bar. If the sway bar and panhard bar have good bushings and rest of the joints [tie rod ends/shocks] are good...
^^x2^^ For me that also worked best. 306 in a '71 Torino, 4spd, fabbed dual exhaust manifold similar to Factory CI but made out of SS flat stock,...
I bought a '92 300 EFI-5spd new. Still have it. 137k miles. Tires are pretty new, the brakes are good and the engine has a heart of gold. Being an...
Did you over bend [arch] each leaf? They do come back a bit once loaded. If you bend a leaf and then put it on the floor arch up and step on it...
"" Then, the main actor didn’t have enough hand strength to open the door with the outside handle. "" Doesn't that beat all?
BARF!
The mouse had to get out!
The wife didn't think so...
Does it have to be '57?
^^2x^^ Modern oils will loosen up/dissolve a lot so changing oil frequently is key.
Well with the line of sight through the inside outside sheeting where did the bullet end up in the shop or did it stop at the hood? Now you don't...
Using a Merc rear can get you a 4.27 gear set [sw I think] and would be a Dana (#) but having tapered keyed hubs requiring safety clips?
CT also.
Yes a tack welds or two would stop the "C's from moving. Local Superior Spring used to do that but the thought wasn't to raise the car so much as...
Couple wrenches too.
Separate names with a comma.
The Jalopy Journal
