The Jalopy Journal
Are you building it to keep forever? Chances are if you build it it will be with you for a long time. Yes it may be rare but the could mean that...
Tried to post photos but can't figure out how.
Have a friend, Ron, that has a good ( I never heard it run but he told me so) 1956 Buick engine and trans. He is in AZ if you are interested....
You should marry that girl, she's a keeper. Girls interested in you projects are hard to find.
I am building a 57 Metro for my wife. Installed a Oldsmobile Quad 4 with a Mustang 5 speed trans. Mazda Miata front suspension - narrowed 8" and...
I have never tried nylon type dies, but the dies need to be the same dia.
They are correct about the solenoid burning out, and even if it didn't it would run down the battery. To use to just get through inspection...
[ATTACH] [ATTACH] [ATTACH] [ATTACH] This was a 40's midget I restored a few years ago. Ran it one time with a cracked block, just to...
I personally think it will look fine. You will see very little if any of the frame unless you crawl under it. Where the frame horns come thru to...
Any good spring shop should be able to reverse it for you
Cadillac used to make thicker head gaskets for cars that were sent to Mexico and other places that only had lower octane gas.
The problem with putting that solenoid in the rear is a couple of things. Keep it away from the battery as it could cause a spark. The other...
Ryan????
How is the width on that front suspension? Is it as good or better then the Voltaire ?
If you widen the inner side of the fenderwells and extra 4" or as suggested 8", you would also have to narrow the frame and suspension points the...
Lots of good ideas posted. However if you had a multi-car garage like aI have you would soon fill it up and need more space!
If you are using a dual master cylinder you should use a portioning valve. The type of valve that goes in the line to the rear brakes is not...
When I did my 40, I used older GM motor assemblies. Worked great!
Separate names with a comma.