The Jalopy Journal
This is for sale in the classifieds ,,I wish it was in Australia,,[ATTACH]
8 port head ,,I'm not putting dividers in at this stage ,it's a 181 engine from a boat with a new head ,,the block has rust so I'll see how it...
56 F100 ,,from Randy Gross in CA.
Here's my take on the intake ,still partly complete ,,8 port head ,,had some plates cut to go for fabricated headers ,,it's looking tight ,,small...
[ATTACH] According to Gary Page (Aussie axle dropper) the bottom axle is known in Australia as a Canadian 32 axle,,he's only seen a few in his...
I have a 2 post outside,,I had a galvanised sheet cover made to go over the top rail and a motor cover ,,the plastic oil reservoir gave up in the...
[ATTACH]
Mid 50s pickup as far as I know ,,
Always glad to help Scott ,,the wheel cylinders I have are just a rusty lump so I thought it'd be easier to install the late type ,,I presume...
We are doing a front end redo on my sons A coupe ,dropped 32 axle ,32 stub axles ,hydraulic brakes ,,it's probably a roundabout way but down here...
They need a TV....!
[ATTACH] [ATTACH]
[ATTACH] Found this one at my local Carburettor place ,,although I'm in Australia I'm sure it would have been imported ,,it was in a blister Pak...
Sure is unbelievable ,,it's like the post office had one laying around from a previous loss ,
Yes,,nice job on the adapter plate combination of the bearing retainer and the clamshell mount in the one plate ,,that will give you a bit more...
That's pretty fancy ,,got a few more ponies than mine,,
This is my answer to the 8 port head / manifold problem ,,as I'm in Australia we don't have any of these engines except for boats ,,mine is an ex...
Anyone got a spare Mercruiser alloy finned side cover they would let go ?
Hi Charlie I'm using some different offset bendix backing plates ,MT products used these and a backing plate spacer ,,now only use the one on the...
[ATTACH] MT Products no longer make these ,,does anyone know if other suppliers have them ,,5.5 bolt pattern ,I'm doing a brake drum conversion...
Get on Aussie Hambers on Fbook put an ad on ,,they are often on there for sale ,,
Mine was done at a local machine shop he as a lot of good machines and does a lot of this work, shaft wasn’t annealed and I was assured that it...
[ATTACH] Lorne Australia early 60s,,,a local with his hotrod ,,it's still in the family but dismantled ,,,
[ATTACH]The seal runs behind the spline on this one ,,realise too that the stock Uni clamps against the rear bearing ,,I welded the washer to my...
No on the shaft behind it ,,I’ll do some more pics of my parts tonight,,
Use the machined down extension housing end that holds the bearing ,,adaptor plate/clam shell mount has seal installed in mine,,,
http://www.macsspeed.com/index.php/products/macs-speed-shop/aluminium-castings/model-a-b-ford-adaptor-lh-or-rh-drive-detail
[ATTACH] A snapshot in time I was actually at ,I might have even taken the pic for these guys , we were going to souvenir the Narranderra sign but...
If you use the AA Bell I don’t think you have to cut much at all from the centre member,,I have just sold a AA Bell ,but I’m in Australia,,the...
Separate names with a comma.
The Jalopy Journal
