The Jalopy Journal
Is this a flathead??
Go here look at pdf on bell housings. http://www.btc-bci.com/~billben/flathead.htm T
Buy a diversion good entry level tig.That welder is under a grand for a reason!!
Pin it I have done many with great results. Have been doing it for 25 years. "Iron tite" "Silver seal" seal lace "loc n stitch" all have a...
http://www.stumpysfabworks.zoomshare.com/2.html T
What kind of measuring is that? .280" 1/64" equates to .0156" what is this .280" Tig
That nest of wires with the marrette connectors is that the foot pedal cable or the voltage input line? http://www.ssccontrols.com/TIGchart.htm...
You may have an 8ba pan installed some didn't return to pan but a threaded hole in block as seen in the picture.Either way works.59a return line...
Will this help.
Tig must be squeaky clean it won't tolerate rust in any small amount You will also have a steep learning curve on thin material.Yes it is doable...
None of it is really required.Actually some is harmful read and enjoy. T
http://www.wolferacecraft.com/pinionangle.aspx
All flathead ring gears are installed and removed from the starter side or back of the wheel. Only heat the ring gear up red hot in a couple of...
Where did you take oil pressure from before filter or after filter?
It will come off
http://www.locknstitch.com/
Yup
No flux when welding mild steel,only with brazing . Use tig rod for gas welding if you desire.You can use a tig rod anywhere.U can use mig wire...
Happy Easter
Get Rid Of This Spammer
What kind of welder are you attempting this with?? I have done dozens of them and haven't been stumped yet. I do use tig nothing else. Works...
#1 is on passenger side
Spent 25 years with a ring company. Or course you use oil during assembly.Bare metal to metal contact is a recipe for disaster!!!What do the rings...
Try this Tig
Hastings 2m568 .060 5/64" top & second groove 3/16" oil groove T
Need a picture?
You should pin that crack not hard to do.Welding your crack is a recipe for disaster.pinning is designed to repair that. T
You could try umbrella seals to get some improvement. T
Can be driven out from inside with a drift if crank and rods are out looks like this.Or use a bolt and pull with knocker. T
This is what your gaskets should look like if you are 48 and up.The one with the bump on the front (top one in pic)goes on passenger side R/H....
Separate names with a comma.
The Jalopy Journal
