The Jalopy Journal
I dyno'd my 350 with a vintage dual quad intake and a Howards cam. I think is was getting around 325 HP. I also had 2 comp series carters (500...
I always liked the color of my old Halibrands with the DOW 7 finish. I attempted to recreate it on the rear rims on my current project - Caution,...
Just by looking at that pedal, I can see how it can jam. My dad removed the factory gas pedal years ago on my 59. He threaded the arm on the back...
I put an M-20 from a '69 Camaro into my '59 Chev pickup. The Hurst comp plus shifter was a little tricky. I moved it forward about 4". This...
That looks like an Oshkosh HEMTT. Awesome rigs Thanks for posting
On your new starter, are the mount bolts directly across from each other, or are the at an angle?
I'll get the driveshaft yoke depth measurement & let you know. Once I'm all set on that, I will make sure the runout is ok. thanks again
Late 60's Olds O4B-Q edelbrock intake. Note, this is the rare spreadbore version. Price includes ship US only It looks like that sample pic...
I'm selling a pair of unused Sharp valve covers. Will need to be drilled $300 including ship. These are rare. Fit all late olds V8's, 64 & up...
I'm selling a custom tack drive distributor by Kerry (see link below) Has new Pertronix module installed. Email me for a photo This was needed to...
Thanks for that link. I'm going to get one. The needle pilot brg came installed from chevy (NOS - unused). I think the crank # is 1182 or 1184...
The crank has the needle pilot bearing. Will check to see if it sticks out farther ('70 vette replacement forged crank) As for the driveshaft,...
When these saver plates are installed, what's the min depth of the input shaft, & how do you go about adjusting it?
I need to install it because my driveshaft was built with the plate thickness factored in
I just installed an M20 in my '59 chevy p/u. The shifter I used with it was a super shifter 3. The entire mounting plate was remade so the shifter...
I have an early 60's Ansen 2 piece bell & block saver. The block saver plate is 1/4" steel, & it installs between the block & bellhousing. fwd of...
On the back of a T-shirt, lol I sold this set of wheels 14 years ago. Attached is the photo I took in 2001, along with a couple of pics of the...
Separate names with a comma.
The Jalopy Journal
