The Jalopy Journal
National Chevy
Congrats Todd.
I am not sure if the nano would work for this application. It is very small and would not be "locked" in the cradle of the Sony unit. I use an...
I put a "retrosound" dual voice speaker In yesterday and it sounds good now. If you are only going to do the center speaker in the dash, I highly...
I only have the listed OP Sony unit, no other existing stereo. The Sony unit wires the docking cradle to the speakers. It can be used as a...
You can get the Sony and the dual voice speaker for cheaper than the Kicker unit. That's exactly what I did in a very "familiar-to-you" Chevy and...
Tod, I just put that system in your old Chevy. Worked great, hooked up to the single speaker in the dash. No amp or existing radio needed. I just...
I ended up bending a piece of flat steel that I had laying around the garage. I put in enough bend to clear the protruding dust cap. I put a dab...
They are still taking orders by phone.
Sony part number XDP-MU110 looks to be it.
That actually makes complete sense. Thanks.
I am looking to put some bullet center caps onto the '57 Cadillac hubcaps that are on my 50 Chevy. I have read that the bullets have a threaded...
Welcome from down the road in Jackson.
That wheel came out great. Nice job
Seeing your Dad's reaction must have made all that effort over the years worth it. Great story. Congratulations.
Iplay America is located at 110 Schanck Rd. Freehold, NJ. It is on the corner of Rt. 9 and Schanck Rd.
You can always come down the block Mr. Punk and take mine out for a spin.
Thanks. It's got a big block Ford 460 engine paired up with a C-6.
Here is my '26 T. I picked it up over the winter on a trade with a fellow HAMB'er. Been busy re-doing the interior and getting the mechanicals all...
Anyone know the size these drums should measure so I can compare to what I have?
Damn, never thought of the shoes being ruined as cores. That just added another $50 to this project
I recently traded for this '26 coupe. I am beginning to gather all the parts to rebuild the brakes on the front-end but I am unsure as what year...
I was heading to a cruise night yesterday and decided to just stay on the road and keep driving. I had a much better time behind the wheel...
Wow that cleaned up nice.
Thanks guys for your tips. I have no idea what master cylinder was put in prior to me getting this car so I don't anything about the bore sizes....
The lines going to the rear are a smaller diameter than the ones going to the front. I can swap them at the master cylinder without an issue since...
I am trying to figure out a problem that I am having with the brakes on my Coupe that I picked up over the winter. When driving at any speeds...
Here it is: http://www.jalopyjournal.com/forum/showthread.php?t=645511
Job well done to all at A.S.S.
I was looking for a starting point to tighten them too. I think Bruce's post points me in the right direction. Thanks.
Separate names with a comma.
The Jalopy Journal
