The Jalopy Journal
if its a billet cam it would need a bronze gear Larry
somebody done got pissed and shaved her head and put a hog ring in her mouth, but I am glad to see that she carries a meskin blanket around to...
till what evens out? retard it from where it was when you broke the starter Larry
yes Larry
normally, when an engine kicks back and blows up a mini starter its because its too far advanced Larry
try moving the dist while cranking until you get it to fire until you find the sweat spot, and make sure your battery is fully charged and the...
is it a bronze or cast iron gear?
bout time you posted this, now put on your gullashes and come over and help me wire my truck :) Larry
nope, nothing
ck out sandersonheaders.com they make good headers for all kinds of special applications. I got a set from them for my 50 pu with a big block, not...
did you get a written quote? Larry
If it doesnt want to stall in stop and go traffic your problem is not going to be the accel pump or fuel mixture, from your description it sounds...
rust is rust, old paint is old paint. Larry
voltage will drop when cranking, ask him to put a test light on the neg side of coil and see if it flashes when cranking the engine over Larry
across the primary terminals very low resistance, say 1.5 to 9 or so ohms, from primary to secondary high resistance approx 1.5k to 2k ohms Larry
there is also a voltage sensitive diode which lights up red below 11.5 v, yellow 11.6 to 12.2 or so and green above 12.4, a local indy bike shop...
yes, to get the benifit from a 4 bar setup the bars should be 180 degrees apart close to the axle centerline and parallel with each other in the...
thanx again for the help Dave. I hope to fire it up this weekend. sorry Tat, no shitty radials on these slots, they are shitty M/T S/S bias ply....
and I would have to answer, boyd? who is that?isnt he one of those kaliforny dudes? it is comong together nicely due to the help of many good...
We got the cab transfered to the new frame, BIG THANX to David a.k.a. D.W. and Jack and Lulu of "The Thunderbolts" and my son-in-law, wont be long...
Thanx for the comps, I will owe alot of favors after this project is done, lots of friends have pitched in to help. Larry
Starting the plumbing this weekend, then maybe after Thanksgiving start moving sheetmetal. Larry [IMG] [IMG]
Got the headers and driveshaft yesterday, sure glad we notched the frame for the steering shaft, now it is all dissassembled and at the...
GOD bless you and your brother, and all U.S. veterans. Larry
BB 2 plus heads, block is out of an old jet boat. Larry
a large tire on the front of my buddies 67 Kaiser PU, a tire attached to Rockwell axles with 4 wheel steering and motivated by a large v8 diesel,...
A little more progress. [IMG] [IMG] [IMG] going to tear it down tomorrow for sand blasting and paint Larry
A little more progress today, should be a rolling chassis by this time tomorrow. Larry [IMG] [IMG] [IMG] [IMG]
[IMG] Larry
is that latin for "paint me please" Larry
Separate names with a comma.
The Jalopy Journal
