The Jalopy Journal
this gear drive came with a thrust bearing. shop was closed so shop was empty, never enough lifts. a clean shop is a happy shop :) and for all you...
that is one "slow truck" :) Larry
I know it's not too traditional, but the birth of a new rat motor is still special. This is the 496 I am building for my 50 Chev PU. Larry[IMG]...
D.W. is running a TrueTrac in his blown Model A, car drives very nice, ask him about them Larry
only if you leave it primer and never paint it :) how you doin Eddy, recovered from all that haulin yet? Larry
vintage bling bling vintage bling bling vintage bling bling vintage bling bling vintage bling bling vintage bling bling vintage bling bling...
where did the DW clip go? Larry
thanks for the info, those links have been saved. the 54 GMC has a rad support that I plan to use as the one with the clip has been clipped,...
What width do I need to fit a 9 inch Ford rear end under my 50 Chev pickup? I bought the truck a couple of weeks ago and it has a 78...
or your gauge or sender are going bad, do you know what the actual eng temp is, middle of the gauge dont mean nuthin Larry
..........this weekend???? If so, lemme know. I wanna go.
will be there. where is that sticky? Larry
when he is done, if it is ugly, so what. Its still his car, not like he is wanting to come and butcher your dreamsycle Larry
its his car, so STFU Larry
I hope he used a good water sealer on the 1x6 intake adaptor, wouldnt want it to warp and knock off those nice hand carved outer carbs maybe the...
elect fans are great,we installed a pair on a friends model a with a blown SBC, tip: wire the fans through a relay with a constant power supply...
CedarPark has a big brand new park-n-ride lot just north of 1431 on 183, nobody uses it anyhow, why not move to it, we paid for it Larry
#3 RPU belongs to Billy Merkur. Thunderbolts CentralTexas Larry pm if you need his number
on alum heads either pressure test or ck with a dye kit Larry
what brand of gas do you buy, I think their stock should be going up. with the money you are spending on gas you could buy a little car to commute...
http://www.kontinentals.com/drags06/
been there, done that, have the t-shirt. if the cheap repair works people sing your praises, if it fails again soon your a crook that does half...
just raggin on ya, didnt mean to make your pussy hurt :) Larry
maybe you should take up knitting or collecting antique dolls,sheesh, what a lame assed post Larry
I had a neighbor complain about noise from my bikes, she had the police come out, guy was real nice and said a neighbor made a complaint about the...
the magical "pull back" is the square oring, and it will pull the pads too far away from the rotor if a residual valve is not used, whether its...
residual valves keep the pistons and pads close to the disc, without them the elastic action of the piston seals pulls the pistons back into the...
the main diff's on power assist or non power assist are the piston rod hole depth and bore diameter, non power brake cylinders have a deeper hole...
end closest to the mounting bolts is for the front Larry
sounds like a ck valve in the valve body is not closing and allows the torque convertor to drain the fluid back into the pan. the delay could be...
Separate names with a comma.
The Jalopy Journal
