The Jalopy Journal
Great photos. Can you provide more information on the engine?
Cruized "Steak n Shake" Chippewa & Morganford, St. Louis, Missouri Raced on Hall St. 1958 Chev Impala Sport Coupe.
I'm not sure what the magneto is. The car was evidently used as a racer (no lights, fenders etc). With a magneto, the battery, starter and...
It looks to me that the steering wheel was cut down at center where the light switch knob fits into. Mine is slightly higher and has a slighty...
Dyce, Thanks for the coupster pictures. I am going to start on mine shortly. I will be using a 28 "A" roadster cowl and 31 sport coupe rear...
I'm 66 with 28 Ford AR "AA" Chassis, 31 Ford "A" Chassis (future speedster), 28 Ford Coupster in design stage
My vote is leave it as a coupe. I'm doing an A sport coupe into a roadster. (started with a 31 butchered rear. cut off doors and a 28 roadster...
The distance from the clutch face to the pressure plate mounting surface is 1.125 inch. I just measured from a flywheel out of a low mileage...
With Dwight Bonds adaptor you need to trim 5/8in. from the node of the input shaft. File a small radius on the of the cut to allow easy centering...
Thanks Email sent. I am using an open drive line into a 47 pickup rear, that should cut tthe machine work to a minimum. My engine is mild bored...
This is my first post. I'm collecting parts to build a model A. I need information on a Ford F150 transmission conversion. The tranny is a...
I always run a seprate ground wire to the gauge. That elininates any grounding problems that may occur in the future.
Separate names with a comma.
The Jalopy Journal
