The Jalopy Journal
Sometimes the gas boils in the carb and the escaping fumes flood the engine when the car's hot. It's called heat soak,I would try another gauge to...
They run great,just make sure the end carbs close all the way.
Count the Car Clowns in.
You have to make the choke richer not leaner and the rod does fit loosely.
You'll have to check the fuel pressure on the car. I've had a lot of fuel pumps going crazy lately due to the ethanol in the gas. We had a dodge...
It was J&J balancing and Bohlander and Shaw, they were across from Pappy at gasoline alley from what I remember as a kid. I never met Pappy but I...
Call Treadwell Carburetor in Treadwell N.Y. He may have a bowl or even an NOS carb.
I've used the pumps with no problem.
I heard the same story in North Jersey in the early seventies.She was supposed to have a Vette.
Yeah they called me too.Just said they had a problem with them and would give me a refund and send a pickup label. Sounds like the're doing the...
Put in an extended throttle shaft and put the kickdown on the drivers side.
Metro hydraulic does a good job, they rebuilt my floor jack and the're right in Newark on Rte. 21.
If both screws are turned in evenly is there any idle drop at all?
Sid's the best,a real nice guy with great service.
Don't forget who loves ya pal
If your vehicle is 12 volts I'd convert it to an electric choke. The trick is finding one that goes the right way.
Use oo glass beads then wash the hell out of it with hot water and soap.
Those holes are to vent the fuel vapors in a "hot soak" condition. When you shut the car off hot sometimes the gas cooks in the carb from the heat...
I have been using leather accelerator pumps in those because the ethanol in the gas is too dry and rips the blue pumps up.You also have to be...
It's the two small tubes sticking out of the venturi cluster.The ends usually get plugged.
Number 25 was me and my friends. Only it was Jack Daniels.
Finish my Knucklehead
www.antiquecyclesupply.com has paint chips,also Pierce color write @603 942 5610 www.gisnet/~Schmoo
I remember reading specs for those in the invisible Delco book.
We use an ultrasonic machine with industrial soap, glass beading too.
Here's one my daughter and I picked up last week.
I have several boxes of nos tags but they are unstamped. If you want one or two pm me.
PB blaster for a few days then tap the shaft side to side until it moves then try to open it.
No there isn't, only the bowls are the same.
Might be a Carter ABD,that will bolt up to an Autolite bolt pattern. They were used on Lincolns.
Separate names with a comma.
The Jalopy Journal
