The Jalopy Journal
Somebody had said it looked like a dodge that someone was trying to make look like a ford.What if it was a ford that somebody was trying to make...
A pile of parts is what you have there.
I once found a Ford 9inch housing miles away from any road out in the woods.It had been there a very long time.No idea how it would have gotten...
If it walks like a duck,smells like a duck,and quacks like a duck,It must be a duck.
Back when I participated in demolition derbies I would make shifters for my cars that were on the same idea as what you are doing.
Thank you for your service and welcome to the H.A.M.B.
Welcome
It's best not to speak of that kind of witchcraft around here.
Blasphemy!!!!!!!
[ATTACH]
Must be old stock or something but the Champion plugs I picked up today are made in USA.Says so on the box.
I plan on staying with an inline engine.V8's are done too much. I can hardly throw a stone without hitting one.Inline six's on the other hand are...
This is one of the coolest builds I have seen.Keep up the good work.
If that is what you like by all means put that on your ride.It's just not for me.If you keep everything in good tune you don't need to pump the...
And are the best when you need to lay down under the car.I wish I had a system like that.I use a propane torpedo type heater.I fill a 100lb bottle...
If I put a straight axle under the front there will also be a drive shaft hooked to it.
This car while being an around town cruiser will also be my Gambler 500 car.Those of you that are not familiar with the Gambler 500.It's a 500...
It is solid.The guy that had it did some really hokey work that needs to be reversed.When I get the chance I will post some pictures of the mess I...
Yes I do.
I am so anti EFI and computers.That junk creates more problems than it solves.
I want to try and stick with something that I can walk into any auto parts store and buy parts.
I have a tans out of a 63 Volvo that is tiny.If you took the shifter off it would fit into a lunch box.
I guess that I need to poke my head up under the dash and figure out where exactly the heater is.It does not protrude out in the engine bay.In...
Using a 232/258 sure would make it tempting to put an axle under the front end.;)
Yes that is the type of drive shaft it has.I just did not know the name of it.Thank you for providing the name.The old 258/4.2L/4.0L engines were...
I hate thieves.When caught they should be taken to the cross roads and strung up.I hope you get your stuff back.
I'm going to where I have it stored today to take some engine compartment measurements and also figure out what rear end it has.The drive shaft...
I don't have the old engine to be able to check the length.
Thank you Flathead4d.The other option I considered for the repower was a Ford 300 I6.
[IMG]This is it as of today.
Separate names with a comma.
The Jalopy Journal
