The Jalopy Journal
If the water heater has enough BTUs to heat the room the circulation pump is switched with the thermostat to regulate room temp
Electric water heaters are 100% efficient. Just depends on the cost of the KW if it would be economical.
Lots of Chinese ones on Fleabay in the $30 range also
Aeromotive A1000 Carbureted Bypass Fuel Pressure Regulator. Part # 13204 Convert from fuel injection to carburetion, and use your EFI fuel pump....
Sounds like you need to transfer the title.
That red dot should be by the valve stem. Also if it is rotate the tire 180 degrees and rebalnce.
[IMG]
1935 Chevrolet standard sedan. 10 bolt rear end with triangulated 4 link and coil overs MII from JW Rod Garage Factory frame boxed where needed....
Big truck axles are full floaters. No bearings on the rear ends they are in the hub.
CR = Chicago Rawhide Its a wheel seal driver, used on big trucks.
It will fit but the timing marks may not be right for your timing cover.
If you dont have a dial back timing light just extend out the marks on the dampener.
That would be an oil leak not a vacuum leak. The intake charge runs thru the intake directly to the head.
I should take all of 10 minutes to scrub it with 80 grit after your wire wheel. Why not do it?
Oshkosh X3
I believe the digital chargers vary the charge voltage to minimize sulfating. Yes you can get away with the two battery charging but if you are...
AGM batteries require a digital charger for the longest life.
http://www.mustangandfords.com/how-to/engine/mump-0907-how-to-understand-the-holley-4180/ Smog carb
[IMG] Sent from my SM-G900R4 using H.A.M.B. mobile app
NV3500 was put in 4x4 1/2 tons low transfer and 4x4 puts a lot of stress on that tranny and it holds up. Next one up is nv4500 but is not cheap.
I dont really think anyone is going to sell that car for the $100 scrap price.
Whats a car like this worth. Interior is completely shredded. Car is complete but not restorable.
What size hemi should be in this car? Looks original and motor is tight.
Yep 413 is RB
X3 on these stripper wheels
Stick a piece of masking tape on the damper starting at tdc line. With the damper at 0 mark a line at 12 degrees rotate damper to put the 12...
Usually the contacts need to be cleaned and adjusted.
Put a bellhousing safety blanket on it.
Drill a hole in a nut, thread on bolt and use nut as a guide. Use a drill press and vise of course. Two nuts can be locked together if the bolt...
Separate names with a comma.
The Jalopy Journal
