The Jalopy Journal
Safety Data Sheet for Martin Senour don't know what brand you're using http://www.easternct.edu/ehs/files/2014/01/acrylic_enamel_Senour.pdf Just...
THHN resists oil, sunlight,abrasions, but is stiff, I would not have a problem using it in limited auto applications where there is no flexing.
YEP I already verified it when I assembled my 235, turning the crank without the timing gears installed yet
FYI... it was mentioned earlier about whether the pistons would hit valves if timing gear was broken, what happens is with a 235 that the...
Viscosity makes the difference. Too little as in totally worn out oil, gets easily drawn past the valve stems as well as increased friction, too...
Check the section of rubber line under the truck that connects the hard line from the tank to the hard line running to the fuel pump for cracks....
I have driven my share of drum brake vehicles the truck in my avatar is all drum and I like it, but when I was your age things were a little...
Mine did the same thing, the bowl cover (#2 in above diagram) was warped and leaked fuel down the throttle bore when engine was running and when I...
Trying to picture in my mind what you are actually talking about but it's not working.
I sealed an after market H-D tank that was never used before I got it but leaked on a seam, used JB weld and it lasted years before I sold the bike.
Vintage Speed
I would use the proper ohm coil that is specified for the ignitor and get rid of the ballast resistor it should still be bypassing it during...
I would lean towards a failed ignitor unit. Check for voltage to the + side of the coil it should be 12 with key on if so check for spark as...
I bought an alternator from Advance, it failed in a short time bad bearings, took it back got a replacement it failed also, when I took it back to...
My dads 79 vette still has the factory original michelins on it I know it has very low miles on it and is always in the garage but he does drive...
Especially if you follow a lengthy thread, with lots of twists and turns, kind of like maybe reading a mystery novel to near the end only to find...
bolt-on's then ? ratio rockers? MSD box ?
10-1329 master cylinder from 67 chevy C 10 pickup drum/drum front and rear. Has 1" bore. Commonly used for single to dual chamber conversions on...
or sucking in raw fuel that has puddled somewhere from leak down when when it's cool let us know what the insulating gaskets do for it
I still think you have too much of a temperature/pressure differential between the block and the radiator the top tank and half of radiator should...
After running it without cap for 15 mins what is the temp showing on gauge? stat might not be open in 15 mins. level in rad should drop when it...
What you are hearing is called "water hammer" or "steam hammer" I think you have air in system, also is water pump bypass hole blocked by gasket ?...
If it is still hard to start after sitting almost 2 hours I don't think heat is your problem especially with a tunnel ram, that aluminum...
"my brother has poured transmission oil through the carb......." hmmm
[ATTACH] With photo 5/16 line has 1/2-20 nuts
Mine measures 1/2-20 thread on 5/16 flare tubing, Probably different 2G sizes out there, but "tube nuts" are not NPT generally , big difference...
[ATTACH] asking 20.00 to cover shipping and packaging top was warped and was surfaced by sanding to seal better but still leaked some. Probably a...
[ATTACH] [ATTACH] [ATTACH] 1 working and 1 needs restored all there both have 1 and 5/32 venturis
Once it warms up it comes off the fast idle cam, then if the throttle plate clearance is tight or no clearance it will stall, this depends on type...
Separate names with a comma.
The Jalopy Journal
