The Jalopy Journal
I am open to other ideas to create a pulse amplifier. (hopefully for free)
I have a 6 volt sun distributor model mdt-50. I would like to be able to test/set up GM HEI, Petronix converted, chrysler & ford electronic as...
Well I went out this morning and checked the carb, and I had an excellent pump shot! Again thanks for the help.
Jon I opted not to machine the pump as we discussed. I found the area under the seal support spring was plenty to allow the spring in further if...
I determined that the upper "overload"spring was the same as the lower return spring. I removed the lower spring completely to prove my theory but...
The carb # is 4131s if that helps at all. (66 chrysler is what i came up with)
I measured the washer and I come up with .7115". So is the pump inferior in sizing or is it the 3/4" pump? (again my well measured around...
Yes you are correct at somewhere around 2/3 throttle opening the pump will force down and deliver fuel. But next stroke will be stuck at the top...
Thanks for help. As I originally stated the pump works good until the next day. No pump shot present at the nozzles but 5psi on the gauge prior to...
Do you have his contact info?
Bttt.
Don't over look the possibility of a worn fuel pump push rod. Fought one after full break in and over 2 hours of running. Then quit running and...
I have a 66 chrysler new yorker with a 440 and an original carter afb 4131s. The problem I am having is the napa parts kit accelerator pump is...
Well I bought the capacitor kit and installed it. (mark from paramount distributors was a great help with a detailed article for the install).....
Would you try to run it with out changing the capacitors first? Will it harm it?
I just picked up a sun mdt 50 distributor tester at the spring flea. Any suggestions before I try to fire it up and run it? I see a "capacitor...
The purpose of this post was to get a useful response to the question of the perch to spring relationship that was described. I value the insight...
To be clear... The 3/8" is the gap at the back of the perch with the other side cinched flush. I do realize that the two springs are different,...
Old school technology, but effective from what we have seen so far. Alot cheaper then the 4 link set up too.
The info on this forum is second to none! With that said I need some insight from some people familiar with the install of super stock springs (70...
I am in New York, and I tried getting rid of a 5 gallon pail of anti freeze. Had a shop that would accept it but would charge me a proportionate...
I was being led to believe that the long clutch is not an opposition with the 833 transmission. Also i should note that funds are low, so the...
By the way this is race only....
What style of clutch would be ideal for a 70 dart. Going to be running a 416 small block. (340 with four inch stroke). Estimated horse power...
Bump
More detail on this "Ronnie Sox"mod please any detailed pics? Sounds like what we would love to do!
Sounds like it's time to axe and check it! (that would be chop it up with an axe and write a check for a new one)
Just won the bid on a x c8... Can't wait to pull my hair out.. What do you guys think , instead of connecting the two plenums to correct the...
sorry, that is correct about using the steel shift fork in the 833 trans. I forgot to include that note. WE are going to attempt this ourself, due...
Talked to a very knowledgeable person named Paul at Liberty Gears today. There are three different ways of modifying the trans. #1-Slick Shift-...
Separate names with a comma.
The Jalopy Journal
