The Jalopy Journal
Wow, I love that last set of seats! Post more. Thanks. Peter
Very tasteful.
Off topic but does anyone know the name and address of a construction company in Mound? I need some work done. Thanks.
I just picked up a brand new, never used Miller syncrowave 180sd. Tig, stick machine, with a full bottle of argon, filler rods and stick rods, and...
Hmmmmmm............
Hi guys. I have a 78' [for now] 302 for my truck. I want to put in a AOD trans. but are there issues with the balance? Which ring gear should I...
What is your gas pressure set at? Open the wire feed drive on the machine and pull the trigger [just so you don't waste wire]. What does your gas...
Good advice, thanks guys. I was going to do a test panel anyways, but to figure out how to spray, not so much flash times. Peter
Which linkage?
Hi guys. I am going to do my very first paint job this weekend. It's the suspension of my truck, differential, 4 bars etc. I bought PPG Omni...
United Nations
Wow! This is awesome. I have been getting a bit bogged down on my on build, but man oh man, I am inspired now! Who needs five hour energy drinks...
welcome from Paris Ontario.
When the car ran 11.81 what was the trap speed?
How would you build a motor to keep low end power with no back pressure? Peter
Wow that thing sits low!
Haa!!!
How do you think these [64cc] would compare against some Edelbrock performer RPM heads. Thanks. Peter
I see in the Jegs flyer some Ford Racing GT40X alum. heads $469.99 each. 64 or 58cc. Does anyone know if these are the GT40P style that need...
I see you already have it welded up, but didn't your brackets have a cutout for the axle in them which solves your question? I put a welder...
82-92 camaro calipers I think. Peter
What would an average price be for 'standard' machining of a block. Say just small block motors nothing exotic. The typical work done to make the...
A little while since I have done this but 1 degree at 12" would be .21" I think. Peter
Is there any noticeable difference between this and the regular clutches?
Hi guys. I can get a good deal on a Ford racing 8.8" track loc rear diff. It is Jegs #397-M-4204-F318C. It is carbon fibre clutch plates. I am not...
HHHHHmmmmmmmmmm........... 351W huh? OK. So if I decide to go 351 route, is there a motor out of what to look for? Probably want to use stock...
Budget is a few grand anyways. Yes the engine is going in my truck, but it is not going to haul anything, just a daily driver. No real racing just...
What is the vertical travel of your shock setup? Peter
Hi guys. I plan on building a sbf. Probably 302. I don't have a motor, I am starting from scratch. Looking for about 375hp when done. What is the...
Ride height is exactly that, the height that the car will ride at when finished. The weight has nothing to do with it. The main reason why you...
Separate names with a comma.
The Jalopy Journal
