The Jalopy Journal
After soaking the door handle inside and out with penetrating oil turn the handle almost a half a turn clockwise and wiggle while you pull and it...
That would be parallel 4 and I did think that it was to short.
Thanks for the speedy replies, the reason for my question was that I can get a set with 12" and 14" lengths.
I'm thinking of putting a 4 bar set up in the back of my Model A. Is their a certain minimum length for the top and bottom bars?
Thanks for the info.
I am planning to replace the ends on my ladder bar over the Winter, how can you tell if they are right or left hand thread? Thanks - Jerry
What do you guys think about using a ring gear spacer in a Camaro 8.2? I want steeper gears and don't have the money to replace the rearend. The...
I have a 8.2 rearend out of a 69 Camaro, can I use a 3 seriesdifferential carrier out of a Skylark GS 8.2? Thanks - Jerry
I have a 28 Ford coupe w/sbc(283), 4 speed and a GM 8.2 w/ 2.73 gears(no cajones). I don't have the money to convert to a better axle and have it...
Since I replaced the points with a Crane points conversion(CR-1) do I still need the ballast resistor? SBC 283 stock distributor and coil....
Thanks for the info. Jerry
I have a 28 Ford coupe w/8.2 rearend and 2.73 gears. The rearend has been cut down to fit the car so I want to stay with it. Can I put in 3.55...
How much trouble/money is it to convert a 1966 SBC(283) to a roller cam setup? Is it worth it performance wise? It is mainly a street machine.
Separate names with a comma.
The Jalopy Journal
