The Jalopy Journal
On oil leaks that are hard to confirm the exact source I use an oil dye kit. The kits with the small illumination light are not expensive. Most of...
The empty boxes included in the front finned backing plate set I bought showed this info: Wheel cylinders - Benxix 33206 & 33207 or Wagner 35325 &...
You are probably aware, but make sure the PV you buy is the older style for the 94 and not the one for the newer Holley carbs. The sealing seat is...
Derale fans are speed rated. Most to 8000 rpm and have a sticker to confirm rotation and speed rating. Several outlets sell them if you want to...
Like many parts of the country, there has always been a strong and direct connection between hot rods and racing, be it drag racing or circle...
Just curious about your cam specs. Is that a cam ground for the 1.8 rocker ratio?
Not sure if you are looking for a clutch to race, or if you envision street use. When exploring your clutch options have a good talk with the...
Ounce you get it to the point you want to store it I would spray it with LPS 2. It will dry to a film. As an addition layer of protection you...
roman, if you are new to the flathead world and all of the engine and transmission variants it might be cost effective to have Mac VP assemble a...
At this point I would buy it allowing for the worst case of sleeving all eight holes. Ounce you have it home borrow, rent, or buy a FIXED hone...
I would look at cannon plug style connectors.
Looks like it might be a Frankland. How many splines on the change gears?
I am assuming that you want to get some bind out of the current setup. As currently built it's more complicated than needed, and you have a lot of...
The manifolds vary as to what, if any, as to the size of the balance tubes. I am not a fan of just running two carbs. If you have six, use them....
How did you use to cut the filter open??
Could file the round shaft into a double D configuration. Here is a old thread about doing it:...
Well, taking some precautions are probably better than nothing. Depending on where you draw the line for max RPM, consider as a minimum a SFI...
Usually you need to get into a thicker spacer than 1/4" to get a wheel register on the spacer. After you get the wheels you really like, I would...
You didn't give much info about what engine, but it may not require what you would call a custom piston. Many pistons are out there as standard...
Separate names with a comma.
The Jalopy Journal
