The Jalopy Journal
Great show had a good time!!!
Anyone leaving from the Wichita/Derby area on Saturday Morning?
I believe that Organgrinder is correct about the amusement park being on higher ground. My family used to go there every year on vacation. It used...
Dickster said the same thing about the idle tubes and he intends to drill them out as well.
I appreciate all your help and I felt obligated to tell you the story and give you all the shortest version possible. After the advice about the...
They are set up to be a true tri power with the outside 2 being secondary carbs. The throttle plates on the outside carbs are as closed as I can...
Rochester 2GC
Ok fellas I need help! I bought a tri power set up on ebay. I have been trying for 2 weeks to get it to run right with no success. The engine will...
Anyone one here ever bought a Tri power setup from adventureracing on Ebay? If so what kind of luck did you have with it and them?
Well, I ran the excitor wire and the fan wire to the acc pole on the switch and guess what? It worked!! BUT the volt meter says the alternator is...
I sure hope this fixes it! Pretty observant on your part to know that this is my first full wiring job.
I have one wire from the pertronix unit going to the + side of the coil and the wire coming from the ign switch. That all. I'm not running any...
I'll give it a try thanks for the help! I appreciate it!
I have a GM 3 wire alternator
I already have the fan wire(which is wired direct with no relay) on the acc side of the switch and I tried moving the coil wire to the acc side...
I have a problem that I have yet to be able to figure out. I just put in my second new ignition switch and it starts the car fine but will not...
Is the conversion of an old distributor pretty easy to do? Any thing special I should know or do?
Thanks guys!
I'm getting ready to put a tri power (using Rochester carbs and an Edelbrock intake) on my SBC in my T. I know the HEI distributor won't clear the...
I have all the carbs and they have already been worked over and ready to go. I also have the linkage and aire cleaners the only thing I need is...
Those look FANTASTIC!!!! I'm going to go with the 3X2 intake!
About $150 from Speedway
The carbs I bought have already been worked over to make them operate as a true 3X2 set up. All I need to do now is just get the intake and bolt...
a New 3X2 intake is about $300
I just bought a tri power set up ( 3 Rochester's) for my "T" and I have a question. Has anyone one here used the adapter that can be bought from...
Here is my favorite!!! But I might be a little prejudice
Hope to be in the group with Yblock292. Looking forward to being in such a big group going up. Should be fun. Does anyone know the rules as far as...
Thanks for the comments guys I really appreciate them. I still have alot to do like finish the top and a butch of odds and ends but its finally...
Well here it is after 2 years of work and many mistakes its finally road worthy. Tell me what you think
Thanks Fuddpucker! I appreciate the encouragment. I just don't want to impose on him too much!
Separate names with a comma.
The Jalopy Journal
