The Jalopy Journal
Agree with previous answers, assuming the switch location is below the master cylinder. If not then air will enter the system. How much will...
[ATTACH] [ATTACH] On the left is a '56 gear, and on the right is a '57 gear. As you can see the teeth are cut in opposite directions. The...
Take the bumper off the front and install it on the back. Then fit a split/quarter bumper on the front, (reproduction mk1 Ford Cortina and Escort...
Call Don Hyde (no relation) at Fordcraft. He has them in stock. No web site, phone# is 972 423 4636. Located in Murphy Texas, a little north of...
[MEDIA]
They now have their own original music for the just completed 2024 event. [MEDIA]
There were too many modern cars for this post to survive on the main board, but hopefully OK here. When American car culture nuts in the UK...
1973 Santa Pod England...Side by side again with the Shoe? [ATTACH]
Removeable section for long tube style in two place Thunderbird... [ATTACH] [ATTACH] [ATTACH]
How about the Redhill UK version before you go to sleep tonight?...Sweet dreams! [MEDIA]
Cruisin' not cruise in!!! [MEDIA]
I believe the car hails from Sweden. Picture of engines stolen from facebook page of Nick Pettitt. Over 300 pictures of the event including...
Frame and running gear all 1955 Thunderbird. Story and details from when I first got it can be viewed...
How about a Galaxie built for two?....."The Spinster".... [ATTACH] [ATTACH] [ATTACH]
And the contents... [ATTACH]
How could you resist with packaging like this... [ATTACH] [ATTACH] [ATTACH]
For me it's hard lines only, with AC style glass bowl filter. Remember a steadying brace near the filter. [ATTACH] [ATTACH] [ATTACH]
Glory days, well they'll pass you by... [ATTACH] [ATTACH]
Here is a little inspiration... go for it! [MEDIA]
[ATTACH] [ATTACH] [ATTACH] If Ford had stayed with aligning the Thunderbird styling to that of the full size lineup then by 1963 it might have...
1st SUV....[ATTACH] [ATTACH]
No! No! it's not DEAD.... It's just resting!!!
Rocky, you are right about water in the oil, but it had only been there for a few minutes. One of the rocker stand bolts had gone into the water...
In order for the piston to move freely through the cylinder bore pressure has to be applied to the center of the piston evenly throughout the...
If the oil problem is really caused by a blocked galley and not worn bearings then this method will usually clear it. Remove rocker shaft and...
Valley pan with valve and grommet installed in draft tube location. This pan happens to be the elusive "E" code variant, note indented top...
2 out of 3[ATTACH]
I suspect you are working with a cross drilled center journal camshaft, as opposed to the later grooved one. If so then turn the engine a few...
If you have to have a scoop, it has to be Little Bird, [ATTACH]
The ball bearings referred to are located on the outer circumference of the breaker plate and when they seize up, and they do, the only part...
Separate names with a comma.
The Jalopy Journal
