The Jalopy Journal
Go say hello to Ralph Moore in North Pole. Helluva' good guy.....
Young guy, a little smarter than the rest us......I see an education in his future
Boiling water. Acetone or gasoline work too. Use the acetone or gas cold and very ventilated......
Georgetown would be cool. Kinda' funky in it's own way....
Good luck. I just went through the cost estimation for an 8".....About $1400 to have a limited slip and gear change built. You can save a couple...
Liquid detergent poured over a hand sized wad of aluminum foil to remove tar and rust...
Try Ken's Powder Coating. Spanaway area. Damn good work, very fair prices. His wife has some damn good jokes to tell.... Pat
So, I don't have a parachute to sit on.... The seats are pretty good using memory foam pads slipped inside of tee shirts. Bonneville road trip...
Does anybody make a cover for the Speedway Bomber Seats?
I'm building mine too. Stretched about the same. I made the ends using 18 ga. angle, forming the contour with a stretcher. Next up is getting on...
When I split mine, I went with tie rod ends Pat
Thanks for the thoughts guy's. I agree that the 8 is plenty good enough. I'm looking at about 300 hp
I'm trying to avoid the 8.8 swap. I'm thinking I'm looking for a vendor to purchase a complete third member from....Any thoughts there?
I'm thinking I would like to take my open diff, 2.75 ratio rear and swap the third member out to a 3.55 ratio limited slip...Any thoughts on where...
Why not just a threaded rod made? Drop me a PM
Keep this one up to the top......Hope your Dad is okay
If you pursue it, the look would be beautiful. I'm in process of reassembling a pair of plated wide fives for a friend of mine. Something that...
Just about anything can be adapted with a little machine work. If ya' need a hand, drop me a PM Pat
I just used a cable for the pedal and the Lokar TV stuff to the trans....Still need a photo? Pat
Get going on a HAMB O'Dex add. Plenty of folks looking for fab help
Saltracer and Plym, Thanks guy's. Salt I have the contact information you sent....I'll call this afternoon. Plym, I've been through the...
Any thoughts on using one? Any ideas on where to go or who to contact to get a drawing or specifications? A friend of mine gave me a couple, one...
Dewalt. The batteries interchange with all my other Dewalt tools
Try Seattle Radiator, should be a bunch cheaper
Re-cutting the splines is really pretty easy. If ya' need help, drop me a PM Pat
What about a Graham supercharger?
Hero status for you! Thank you Dick, much appreciated
Could be the dumbest question since the last one I asked....... What is the backspacing of a wide five wheel? More specifically, they're '35...
What's the application? Can ya' get it on a mill and use a carbide end mill?
When we moved our Bridgeports, we used a rented pallet jack and ramps. Just support the ramps to take out the flex and you'll be fine. Moving a...
Separate names with a comma.
The Jalopy Journal
