The Jalopy Journal
if you cant find merc assemblies, try 49-51 ford club coupe. they also pop out like the mercs. they operate pretty much the same way.
from inside your trunk you should be able to see where the holes were. you would also be able to see where they were if you take out your rear...
ok, first off. a big thanks to jim. not only did he go the extra mile for me, his customer service is second to none! the new distributor arrived...
wow!!! thats some serious customer service. thank you. i have two of the pertronix 1.5 ohm internally resisted coils, tried em both. ive pulled...
hi bruce, this is strictly a mechanical advance dist. no vacume at all. it might be starting to advance but i dont think its right. too rough of...
thanks, ill have to give him a call and have it tested if it comes to that. no more vacume advane on this dizzy. i had them running through...
the dizzy is tight and timing is dead on. (except for the jumping around) ive been breathing gas fumes all day. is there any way to test the...
i just hooked it up to a vacume guage as was suggested. at idle which is set to about 500 the needle bounced between 17 1/2 and 19 1/2. hmmmm?
the stats, 8ba with 400 miles. pertronix in a bubba gm dizzy, new epoxy pertronix coil, new wires, new ngk plugs, new stromberg carb. while...
thanks!!, the tires are goodyear super cushions. 6.70 x 15
thanks everybody, it all makes sense now. i have the pcv hooked up now and it will stay.
a recent pic of my shoe,,, [IMG]
so i was sick and tired of messing with my holley 94 and picked up a new stromberg, the made in england kind. while reading the info that came in...
im with quakemonkey, goodyear super cushions.
quick question for you guys. how far are the hotels from the track and will it be impossible to get a room ? this will be my first time attending,...
ive been down this road a few times myself. the first thing i do now is buy dropped uprights and be done with it. i know you can swap side to side...
going thru this myself with a 51 merc flatty. turns out that the noise we heard in the bellhousing was actually a piston hitting the freshly...
i know they are far from you but, try big m in williams california. i was there over the weekend and they had a bunch of those cars in their yard....
i cant even watch footage anymore, it upsets me too much. what happened to all the american flags that were flying around , on cars, on houses, on...
these guys have what you need. www.ecihotrodbrakes.com
thanks bruce, i was hoping you would reply. im thinking i have the late small spline merc pressure plate and clutch. the splines match the 49...
dirty whites belong in your laundry basket.
i just picked up a 51 mercury flathead. its going into my shoebox. the motor has a borg and beck flywheel, with pressure plate etc. i want to use...
$2000.00? , move along my friend. spend a little more and try to find a better car to begin with.
what is the planned route? can you post a map of it?
and just because, check these out. tuk'n'roller, not nash. made by ray brown automotive. [IMG]
its a 60's nash board. nash made a lot of boards. [IMG]
Quote: <TABLE border=0 cellSpacing=0 cellPadding=6 width="100%"><TBODY><TR><TD style="BORDER-BOTTOM: 1px inset; BORDER-LEFT: 1px inset;...
very nice, thanks ryan!
alright guys, the radiator did leak, now it doesnt. im going with the thought of the head gasket at the leak point is the next weak link. i dont...
Separate names with a comma.
The Jalopy Journal
