The Jalopy Journal
Can you just drive up and get a spot to sell or do you have to pre-register. It is the 22-24 of February.
Who sell the forward quarter panel behind door in front of rear tire. Tryed drakes,ems and bitchen, no help.
I am looking to get a good metal cutting bandsaw, Does anyone have any good suggestions. I live in the dallas area are there any surplus stores...
I hope mine will look half as good as yours as i start to work on it.
Thanks for all the info, No Name how did you lower your truck, Mustang II or camaro.
They removed the front axle and springs, down to just the bare frame. In the rear they did the same, Thus i have a bare frame. This is a short or...
I have 53 chevy truck someone was going to build and cut the axles out. I need the measurements without having the old axles in. From some bolt...
Are doors on a sedan the same as coupe.
My bad it is a 54, what is a fair price to offer
I found one and the guy wants to sell but i am not sure about it. The car is a little ruff, It has good floors and not to rusty but it does have a...
I have a 64 chevy truck with 6 lug wheel pattern and want to change to 5 lug will a newer 5 lug truck like a 70 model with disc brakes bolt up and...
Can some one help out with the ID of this motor.
Does anyone know a place i can get valves and switches in the dallas area.
Not sure yet. I am trying to find more info. May keep close to stock. Heres one more front pic
I picked up this 54 this weekend, It has a olds motor in it. It has been sitting since 1963. It was a service truck for a appliance dealer. If you...
Well SHIT! I better pull it all back down and figure this out. I dont want to launch this. Thanks
I am not sure off the top, But i will take a look at that. I am assuming that at worst case it will just rub for a slight moment. i am not going...
I am using forged pistons, But i am talking touching the counter weight.
I am building a stroker motor and i have installed the crank, rod and pistons. When the assembly rotates the pistons and the counter weights have...
What is the best length for wish bones.
test pic
Whos going to the canton swap on sat
Thanks for the kind words and great info. Looking forward to getting out of Cali. Again Thanks
Well we finally sold our house and are prepared to move. I am moving to north Texas, Van Alstyne, Whitewright area. I used to go out to McKinney...
Check with Killer (Jason) he built me a great frame for a good price. Killer job.
I have seen a 2 barrel carb with throat opening to the front of the car at a 45% angle, I was told it could be a 49 50 olds but that is not it. It...
Where is the best place to 32 rails in so cal. Best price Thanks
Are there any good spots 0n the 93 to idaho to look at car parts and cars. going this weekend. Any help would great.
I have installed the crank and rods and pistons. Question: the pistons almost touch the counter weights on the crank. I mean on most pistons there...
Heres mine
Separate names with a comma.
The Jalopy Journal
