The Jalopy Journal
I'll check it out. Thanks
Here are some photos of my bell housing.
Hi, My name is Steve and I'm kind of new to this board and would like to pick your brain a bit. So I am ready to finally do the T5 swap and have...
Ill give it a shot when I get my new ignition. Thanks
Hi, just tried changing the title but didn't look like it worked. I'm also using the mobile app. Thanks
I did not have a ballast resistor installed because I did not have one on old setup. I thought that that this coil did not require one.
I did install a gm one wire alternator which was ran straight to the postive terminal of my battery. All wires from regulator were discarded. Had...
Hey everyone, seems I've run into another problem.... So did a 12 v conversion this weekend and all went well till I turn the ignition over. I...
I had to remove the bracket the holds the clutch return spring. It free the motor up after. Mounts are in finally. Thanks all for your input.
Only thing I can see is maybey the bracket from the trans to the clutch assembly. Two bolts holding bracket to trans.
Car is sitting on the springs.
Also since then the engine has moved forward about a 1/2" to the radiator.
Yah I removed the engine mounts top and bottom along with transmission mount but still the car raises with the engine. I used a 4x4 block and...
Was trying to avoid using a cherry picker or an engine puller. But I just thought I could Jack the engine up and I would be ok.
There is no place at the x-member to place the Jack. I did not notice it being hung up on the exhaust but I can check that tomorrow.
Hi, I'm looking for a little help changing out my motor mounts and have ran into a snag. I have removed all bolts,nuts on the mounts and after...
I did clean the bolts with a wire brush however I did not know what everyone meant by chasing the bolt. I did torque the bolts per Ford shop manual.
Thanks for the input fellas. Also do I need to add any type sealant to the head gastket prior to installation? Posted using the Full Custom...
Will do. Thanks Posted using the Full Custom H.A.M.B. App!
Hi, I'm new to this forum and have a question about a head gasket job I'm doing on my 53 Ford Customline. I found a lot of carbon buildup on the...
Separate names with a comma.
The Jalopy Journal
