The Jalopy Journal
If you are trying to reduce the steering effort at the steering wheel the caster adjustment you made will help, but a longer pitman arm will...
Thanks for the memories Danny. Wasn't at Peoria but at many of the early east coast runs. Still have the same 31 Chevy, currently under going the...
06 made it to Maine today. Thanks Saxman for the fine craftsmanship and Ryan for all you do. The 31 Chevy will wear it proud. Bob
Sam. You already have a front sway bar so that should keep the body roll and sway in check ok. Keep the rear bar for possible future use. A too...
Mine has made it to Southern Maine, now it up to the postal dog sleds.
Good score Sam. Good to see you and your Dad this morning.
Thanks Ryan and Saxman.:)
Yes....:) 61?
Leonard's Mill has been changed. Road is not passable. Check with Smitty, I think they are going to Fairfield ?
Sam, I have some of the GM wiper ends. Will have to see if they are the same shaft size. You going to be at the Island run tomorrow?
Nice SW gauge Sam. The fuel gauge may work. Worth a try but may not be accurate. If you have the sending unit out of the tank you can try it to...
Try to find a place that can spin balance the wheel, tire and hub/rotor on the car. I have had similar issues with a camper trailer and have...
62 S 22 seats.[ATTACH]
Not sure Craftsman will warranty that !!!
The studs don't need to come out. The heat riser should slide down off of the studs. If it is rusted a few taps may get it off. If not it may need...
Good Sam. Get all the safety things done before you run it to much. Proper dual throttle springs, neutral safety switch, brakes, etc. Don't take a...
Willebones got it !! 91 capri [IMG]
[IMG] Volvo V60 similar knob
Some Volvo's have open head rests.
Welcome from coast.
Ok, may be a little slow filling if the slope of the pipe near the cap is shallow.
How far is it above the top of the tank?
61 Biscayne.
Hi Sam. The heater core will work fine with a box and vent hose to the defrost and one to the floor for heat. Fan into the backside. Do not put...
GMC truck 16 to 15 reducing rings. Part no. 348196. Used on 3/4 ton trucks late 70's to late 80's will mount most 15 inch wheel covers to a 16...
Address the rust areas and use this stuff and it will get you a couple years. http://www.poliglow.net/?gclid=CO2r8rWdy8QCFYIdgQodkK8AyQ
Looks good Sam. You'll be towing the boat and fly fishing soon !!
Had a 61 4x4 many years ago but it looks like I remember mine. Same 6 hole wheel, same adjusting cams on each brake shoe. same sloppy lever to...
To use with HEI you need to use the wire that goes to the distributor to operate a relay to shut off the main power to the HEI. When the trans...
Thanks Bill; Nice video. Don't hurry back to Maine; 16 degrees now and snowed this morning !!!
Separate names with a comma.
The Jalopy Journal
