The Jalopy Journal
iT NEEDS LIGHTS AND PLATES.
Here is our lark. tpi small block, 200r4.
I built this one for my wife. Fortunately she lets me use it to.
if the car is supported by the chassis, the rear axle control arms will swing the rear forward closing the distance between the trans and the...
find a machine shop and have the hole tapered, and a keyway slot cut in. I had it done in the 60s to put a 57 ford wheel on my 36 Ford. Make sure...
Here is a pic of A C.O.E. that belongs to my freind Dennis. It has A 350 chev. and A 700r4 trans.
First thing to check is the brake shoe adjustment. Next the Master. Remove the brake line from it, and put an inverted flair plug in the master...
Contact "Joe" at Protorque (they build custom torque converters) At 631 218-8700. WWW.protorque.com. They do all of mine. They are here on long...
Don, I just whent thru the same problem on a customers falcon. The front of the car had been raised (about 4 inches) with springs that were too...
She wanted to know why I needed a dragester chassis on the ceiling. I told her it was garage art.
In New York there is only One.....Gary Kupfer ....GARY THE LOCAL BRUSH
Call brent at fatman. He did a disk brake setup for me on 37 caddy spindles.
I have a mallory Rev-pol distributor #yc-910f for a sbc. It uses a dual winding dual input (one from each set of points) Rev-Pol coil with one...
(contuation) I abuse. no problems 7 wears.
I have a 60 lark conv. with a dana 44 from a v8 66 stude. It bolted in. only mod was E brake cable. it is behind a TPI SBC w/2004R TRANS. WHICH I
G.M. put the T5 trans in 305 ci Camaro's, & Firebirds. They didn't put them behind the 350 ci. the 350 ci were only offered with automatic trans....
The 82-90 rotors, and 82-92 calipers, are the same as the 82-87 camaro "Metric" brakes. You should be able to get mount kit from Chris, at...
Howell engineering makes a wireing harness to run the cross ram F.I. You can get all the sensors & computer from them also.
Separate names with a comma.
The Jalopy Journal
