The Jalopy Journal
while you are in Reno, go to the Summit Racing store in Sparks.
here you go http://67-72chevytrucks.com/vboard/
The fancy house with the gas station down in the valley? He had different stuff this year. Great set up. Saw all the jeeps. Lots of old cars on 36...
these are about 120 miles west of St. Joe Missouri on hiway 36 in Kansas. The Sunbeam is $600, no prices on the other two.
I own the same truck, like it a lot. All your parts are at Rock auto online with very good prices. The Chevy truck site is a good place for info....
know where I can buy it? I searched the web, can't seem to locate any. Will have it sewn on by my cousin.
Did the brakes and cleaned the gas tank the 1st week I had it. New tires too.
I have a '61 Chevy pu I got last month, truck sat for 18 years. Should I buff it out or leave it alone?
who sells them? thanks
so no one has done this ?
looking at the angle of the truck when it is open, I see no way to make them work. Of course that is with the old hinges on it.
any tricks, they go on straight or angled, etc. thanks
Any one else have their engine back this far? Can I maybe move the body back? It is fine, but i would like to maybe put on some Lakester pipes....
what brand, some don't work.
Mine is too. I know my B&M had to be adjusted in neutral, just wanted to check. I think I have it right.
Have a c4 if that matters. Need to know how to adjust the linkage. Bought the car from someone else and Lokar does not have the info on their site.
sounds like the same stuff, I just e- mailed them, thanks
Guy called skipstitch wrote a tech article called "no-sew door panel tech". He talks about it but never says were to get it. I PM'd him, but have...
it was mentioned in a tech on doing door panels. It is chrome strip that is bendable.
where do you get this stuff? I can't find it.
They cut it with a torch and then bolted it down. It had been welded to the frame. I was going to pull it apart this winter any way to clean up...
drives fine, I drove it home 875 miles the day I flew in to get it. He had it a year and never worked on it. I will weld in a couple of cross...
decided to start tearing into this thing just to see how it was built. Looks a little ruff to me. I think I can clean it up, will have a good time...
any one know where I could get some thin chrome for door panels? Straight is fine, about 1/4' wide. Would need about 8'.
that looks just like the stock one I just replaced on my '61 Chevy pu. Mine was a lot cheaper , got it at Rock auto on line. They have pictures...
his '63 has trunnions. You can do it without special tools but the fronts are scary. You will see holes in the spring perches top and bottom. Two...
adapters, I have a pair in the basement. You need 2 more. These are way nicer than my 30 year old ones....
white on my '63
If this was between '63 and '66, I was there with you.
1965 Mustang 2+2 in the summer of 1970. Got the duals for $5 at the wrecking yard. Got one ticket in Denver, a half hour later got stopped in...
Separate names with a comma.
The Jalopy Journal
