The Jalopy Journal
It's off warranty, over 90 days. They said if I send receipt with, they will repair.
Thanks
Called TCI , they said they would repair it , no charge if I send it back. How does one get the fluid drained from the converter so you can ship it?
Yep, had starter the car 3-4 time never been on the road.
Thanks will get the hammer out
The weight is still attached on one end.
Installed new TCI 350 with torque converter. After 3 or 4 start ups I thought I spun a rod bearing. Come to find out the weight let loose on one...
Not afraid to pull distributor, just was looking for short , pulled it , tested , bad, went back, installed points distributor back in.
Starting to look like that, thanks. I have read some reviews like that before I bought, but had figured any reviews you reed have some negative...
Thanks, knew it had to be grounded.
I probably pull the distributor tomorrow and test the module like Petronix instructions state, was just trying to short cut it. I would think...
Trying to trouble shoot Ignitor III module without pulling distributor . I have power to the coil from switch. If I use a test light in the coil...
Love Rakes
Thanks , I do have it setting at ride level with weight on axles
No offence taking, Thought it was always around 3/4 to 1 , just checking after tech I bought through said 1/2 way.
No , have no problem buying new drive shaft, infract I have one that just came but when I gave measurements when I ordered , the new one was the...
Did closer measurements this morning. end to end to bottom out is 1 3/8". The shaft is 4" spline. with 2 1/4 " yoke in transmission plus...
Guess that's a no brainer. I was trying to find out what the + and - limits should be on the yoke. I always though 3/4" to 1" was standard until...
Did bottom it out and check, that's where I'm at ,half way., also the place I got the 9" rear end assembly said it should be 1/2 ways, just...
New rebuilt TCI 350
The yoke spline shaft is a scant 4", so there would be 1 7/8" on the spline
Thanks , I would be looking at 3/4" longer to be at that figure but I know that the measurements I found in the past
Been on there site. Everything I searched in the past always came up 3/4 to 1". I may try the 1 1/2" and see just a cruiser car
Thanks I remember seeing longer shaft yokes.
In stalled a 9" rearend in my 55 chevy. The different rearend move the pinion yoke back 3/4" so now my drive shaft end to end pay is 1 1/2" to...
Unless there a certain one, everything I see says there a standard size cap. If there bigger then the stock points one, like all I've seen, not...
Yes checked it out nothing there, or ever has been
I have the front motor mounts. Everything I've read said not enough room for regular HEI. Not much room to firewall now with stock distributor
Plan on this setup for carb/manifold, carb's a 650, should have all the ports.. That's where I had it on my 50 chevy, carb port . I have brake...
Separate names with a comma.
The Jalopy Journal
