The Jalopy Journal
Thanks, the passenger side has the rubber plug so easy fix. Can I go off the vacuum port on the back bottom side of carb, or in top of manifold...
Just checked back of engine manifold, no draft tube holes
The block code shows its a 1968 . Not sure where draft hole is suppose to be but can see any plugged holes ,
OK Thanks ,yep had my V&C backwards, This is a 1968 327, no tube underneath, can't see any breather hole in back of block under side . Valve...
What vent port are you referring too? The plastic filter I had planned on relocating with different one , it's not quite as close as picture shows.
Thanks, So I can run either from PVC in valve cover to vacuum inlet at back bottom of carb or the vacuum port on intake behind the carb?
Plan on upgrading with intake and carburetor, and ready to run distributor on 327. I have the old intake with the breather/filler tube I'm going...
I plan on small electronic distributor with separate coil, Which Danchuk mounts are you referring to? which fixed your room for HEI?
I have the front motor mounts and replaced the stock power glide horn mounts with Danchuk's 350 conversion mounts( pictured). Have the panel out...
Thanks for info.
Bought last August, Started 350 tranny swap and new Currie rear end assembly. Have new wiring harness to install and planning on new intake,carb...
This is the stick that came with transmission package. If I try to use it I will have to try something like bchctybob suggested. I don't have room...
Checked it out. That looks identical to the one I got with the transmission package. Because of the battery, the only area to come up through is...
Thanks much will check it out
Will look. I have the stock one that I got with new TCI transmission package but no room behind valve cover, exhaust area to get in to bolt mount...
Yep going to have to do the flex stainless tube, tried the stock again, no way it's going in. Thanks
Do the push in ones seal good or better to drop the pan the do the bolt in ones
Lokar states the fill mark is correct, want to make sure filling new transmission
OK Thanks, just thought the review sounded like might take a day to fill
New transmission, Just have the quart in the converter. The post review I read on a vender site said it took for ever to get 1 quart in, He may...
Doing a power glide to 350 swap on my 55 chevy. The stock dipstick tube won't fit, not enough room. Looking at the stainless flex tubes, some...
After some thought I contacted the company I bought the new 350 transmission from. They asked my rear end gear ratio and tire size. Said a 23...
The cars not put together as far as rear end and transmission, have a new 9" rear end 3.50 I'm installing along with the 350 transmission. Rear...
Thanks will keep your contact, probably got ahead of myself car won't be on the road until spring being I'M northern mn, Wanted to do everything...
Thanks, will save this all this information . Found a kit for 350/ powerglide with bullet and gears 17,18,19,20,21,22
OK Probably in the spring, I'm northern MN , winter coming on cars up on blocks with tranny and rear end assembly out. Getting ready to install...
ok thanks
What color gear would I use, the one in the powerglide?
Tried searching couldn't find .swapping to 350 turbo in 55 chevy. New turbo has blue speedometer gear inside tranny. What all do I need to...
Planning on the leaving the front motor mounts and doing bell housing mount and cross member. Have already purchased the bell housing conversion...
Separate names with a comma.
The Jalopy Journal
