The Jalopy Journal
I have 1 with glass lense and non pitted chrome bezel for sale. It does have mounting screw holes top and bottom. It measures 3 5/16 od and 2 1/4...
It seems like wiring in a ford starter relay would cover all your bases for both starter and ignition. Are you now using a ballast resistor ?
Air chisel to remove them, proper size socket to drive new bushing in with hammer. Tighten bushings to control arm crossbar with car full weight,...
Have you considered animals or rats & rat nests burning in the exhaust system.If you are not loosing any fluids it is either rats or your trip...
I would look at other things. Head gasket, if power brakes is brake fluid leaking out rear of master and vacuum sucking it into intake. I have...
I have made a spring compressor for the clutch drum spring with threaded rod, scrap steel and mig welder. A 25 gallon metal barrel with the round...
I have ended lockup shudder many times when nothing else worked with a product called lubeguard .Its a friction modifier ,not snake oil
To prevent ever to replace again .I have always used disk brake wheel bearing grease on the gear,track and rollers and any moving parts. It...
All Chinese parts ?
The plastic "doohickey" would be for all types of valve seals for all makes of cars. To prevent the seal being destroyed being pushed over the...
It could be me but I find it hard to understand how you wrote you did this repair. Did you use the plastic sleeve thats sometimes supplied...
Dont go down the rabbit hole that braking that creates a left or right pull is only from the front wheels and not caused by a bad rear wheel...
As said before a shop manual would be your best investment. The bottom return spring you have, I have seen used on the self adjuster lever on 3/4...
The thumb on the flat spring that fits on the parking brake strut or bridge bar goes behind the brake shoe not in front. This holds the park strut...
The safest you could do is order the shop manual for this car and then do the work. Sorry,You will probably have to bleed these brakes the hard...
Also agree with this,(was ase auto tech and shop owner 40+ yrs)
There is another procedure to get the air out of the system on a angle mounted master cyl system when raising the car to level the master cly....
Have you tried jacking the car up so the master is sitting level and then bleeding
318 had smaller ports than 360-340,the reason for Chrysler smallblock gasket difference
318s always used steel. 360s used the paper. 3m yellow on the cork end rails on block side only,allow to dry completely so they wont push out.Bead...
Is this still available ? It's already priced at scrap prices but Will you take less? Will you deliver or meet me half way ? Ill be there in...
They fall down the cowl vent. I would use a cut to fit black window screen under the factory (usually plastic grill) on my cars to prevent this.I...
Try raise all 4 wheels off the ground and have someone apply the brake. Then try to spin each wheel,will let you know what's working or what...
I see a grey wire for the clock. That pigtail could be for some other option.
As said by others, engines are like people,temperatures affect them differently. I have made a lot of money in both northern and southern states...
With the ports closed it may affect your cold start driving and longer time for the choke thermostat to heat up and unload the choke(resulting in...
They think out of the box how to hide they are the source. I find it a lot in food. Frozen fish sold in paper bags at Walmart you have to unfold...
I would make sure you have one as it will shift to early and have no power and also destroy the transmission.If its all there then we can explain...
If the engine has sat overnight and cold,the choke blade should be closed with a slight spring tension,once gas pedal is pushed to the floor and...
Is it sucking down wads of hood insulation ?
Separate names with a comma.
The Jalopy Journal
