The Jalopy Journal
https://www.pinterest.com/pin/778348748068955858/
Should be .070 but I wouldn't cut over .050
You could get CR increase milling your head
a pair on ebay for $3000!
I swapped in a 440 for a 383 keeping orig. 383 radiator (440 one is 6" wider) and overheated in traffic.
[IMG]
I've got a '39 Olds with rubber bushed locating arms. I am going to add a torque arm to mount atop one of the arms near the pivot. Can I keep...
You can see the front spring end is higher which helps anti dive when braking.
If back is fixed then axle must move forward when you hit a bump, a little harsher. With shackle in back axle will move back as it hits a bump.
The 488 thermostat housing (it has the t'stat recess and matched the 1-1/4" nipple in the head) connected to a Chevy housing in the upper hose....
You planning on running that through a Jetway or expensive TH adapter? I so, look for a later model 455. If it's a stick, never mind.
Chevy has had 3? different timing pointers. I would crank in 10* more timing before I tore into it.
April 2, 2006 with 1805 steel. Looks like Sealed Power 187 is the grind. https://www.summitracing.com/parts/slp-cs-187/overview Cam Style:...
Pick the super duty size you like http://www.vfnfiberglass.com/Factorystylescoops.htm
I made up two 50' 10 ga. SO cords with 220V 50A plug and receptacles and also bought a 35A dryer pigtail and wired it to a 50A receptacle so I can...
Just a thought. I raised a tunnel and neglected to consider longitudinal clearance so I could pull trans with engine in place. I can't see a...
I gots to know [IMG]
Probably not as Gabby was from Chicago and Garlits and Giovannoni were in FL
Civic half size radiators are about 14" wide and cheap
And a W-30 had those huge exhaust manifolds
395558 2. 68-72 small block 350 #5 '68-'69
Look at front of head by plug and see if head has a cast letter (BBO) or near center exh. port for number (SBO).
Drill a small 1/16" hole in it. If below the level should pull a film up.
Neighbor was given a 350 from a wreck that had busted starter bolts out of block. I cut heads off two bolts and nickel welded them in and it did...
Got SR refund 2-1/2 mos. ago, called on CC refund 2 wks ago and told in 2 wks. Waiting. Got June HRM with no subscription cards.
Super nice Tempest with good chrome, especially in the Rust Belt. It's a keeper.
mid '60's Ford truck (mount below) and van 3 speed (mount above)[IMG]
your axle is same width as dragster offerings https://swracecars.com/product/front-engine-dragster-front-axle-torsion-bar-kit/ There is someone on...
Nope. Just the stock head with the AIR stands cut out of the exhaust. Still sitting as another project ahead, Ford 2.5 with 16V Volvo head,...
So is your plan 4.5" bore and cut crank for BBC rods for 260 CID? It will be a shaker.
Separate names with a comma.
The Jalopy Journal
