The Jalopy Journal
The 300 is an excellent truck motor, great for low rpm pulling and durability, I guess it all depends on what your plans for the car are but I...
Don't know what part of ON you're in, but if your close to the border you should ship it to the nearest American UPS store and go pick it up,...
Its mostly offshore, but its definately better then Harbor Freight, probably OK for air tools, but for welders and torches you are far better off...
Yeah, I have a buddy who makes some bio "fuel" too, certainly loosens things up, but I wouldn't waste it on a motor :)
I've used deisel fuel, made a bracket, with four 1-1/2" square tube prongs for me to get a long bar into, that bolted onto the front of the crank....
Actually, the warmer the gas , the better it will atomize, its the intake air that you want to be cool, the cooler air is denser.
I've had the millermatic 135 for quite a few years, excellent little machine, I just recently found a good deal on a used miller 251, I like it...
Thanks for the info, its tough to beat the Q-jet for all round performance/economy/driveability in a daily driver
Stick is not going to work so well, also if the floor is getting punky you might want take a close look at the mounts as well, I had to rebuild...
So why is it that some Ford trucks used to have the rear shocks staggered, with one angled forward and the other angled back?
From last year
I retired at a very young age after helping out a very nice fellow from Nigeria with a cash transfer to free up some funds trapped by a previous...
HAHAHAHAAHAA sometimes you only get what you paid for some will pay extra for that
You just read my mind, up here in Canada the wheel would get covered with frost in the winter due to the condensation from the exhaust blowing on...
Yeah, dropping the bumpers down will only make it look bulkier. Moving them in would be cool, skirts would be nice, but I really think you should...
While I'm sure that the alignment concerns are well founded, why not wait until he's done and tried it out, you never know, the sky may not be...
A single stage urethane or even acrylic enamel will work just fine on an engine block
Thanks for the compliments, the truck is sitting on a narrowed 1980 Cadillac frame with a 472, and the bed is handmade, it originally came with...
Nice!! Lets have a Slick 60's burnout competition!! <embed width="448" height="361" type="application/x-shockwave-flash" wmode="transparent"...
Heres my 63 Merc, just before I tucked it away for the winter
I have read that there is a reverse pin that goes through the back of the trans case into the OD case, is this true? is it as simple as drilling...
Is it possible or practicle to swap a mid fifties OD unit onto a non OD Ford transmission?
Thanks for the reminder, hja;hdgiralk;gk jsajkgiyhlkjrlg;hrg ;asugflarkugil;seg as;ljgak;lrhohaeh aklhfglakhlkrht Sorry about that, I...
Don't have any pics at the moment, but I had to make one for mine, looks kind of like a C-clamp, with a forked pad to go on the spring. It was...
Go jacks are the way to go, they cost a little more up front, but they will save alot of grief over the years
Wow!! I just found the ownership in the glovebox, turns out it is already in my name, I'm going out to buy a lottery ticket, this is definately my...
Keep looking fellas, sometimes the hidden gems are a lot closer than you might think! It all started with a suspicious looking pile of snow,...
I was thinking the same thing, I think it was on the 59 Fords also
T roadsters look great up on top of 32 rails, search again, there are quite a few of them on here
Separate names with a comma.
The Jalopy Journal
