The Jalopy Journal
Check out Panoz aluminum frame. They use diferent angle extruded couplings to assemble thier frames. You can google some good articles.
You will never regret it if you buy a tig
How about orchard supply hardware as they are owned by sears, do they have the same policy.
105 octane
C5 or C6 transaxle and leave out the tq tube. They are t56 6 speeds or autos .
Always loved nail heads for driving on the street. Lots of tourqe and fun to look at,
God blees you Andy.
Wouldn't hurt and would handle better in turns. A lot of it is the front suspesion. Had a 250 pound hs coach in the early 50s that had a 35 ford...
Be safe. It looks nasty.
Strong dollar = lower price
The sheriff dep is being a jerk. Of coarse he does have to fill out reports on stollen street signs but shouldn't hassel you over your vintage ones.
It will do just fine. With your welder it will not have voltage drop and will do for 30 amps which would run close to 3 of your welders.
If it is a 64 motor it has a five bolt pattern for the bell housing and myself would not build the five bolt. 65 and up are 6 bolt housings and...
I always setup the wheel a inch forward of center. It looks better then center and looks wrong back of center.
Yes you are running to high amps. Back it off to where it won't form a puddle and adjust up until it does and keep the gas covering the weld and...
I use 1/8 wall and have great luck. very strong and it is boxed. 3/16 is ok but is 50% more weight and bullet proof.
It will work. Just cut a template and redo hinge holes. Don't forget the vin# Don't know about the fenders but I think they are both the same mounts.
d.b.
Go to club cobra. I had a good one but hot rodders are more fun.
OHFC alloy(oxegen hydregen free) refrigeration tubing which is annealed.
A little lube on the distributer cam.
I had the same thing with my 7 inch saw with a new blade. I adjusted all the roller guides (they have ecentric bolts) and got it perfect. Use a...
Then there is pinks on Melrose and La Brea,great dogs, burgers and fantastic fries.
Sad that it is gone. In the early 60s great fries.
YES I just did the spicer # 5-134 1310 to 1330
Direct drive, not v drive. Engine at prop angle.
It is not a problem and is not going to hurt your welder as long as you use a 30 amp breaker. If you pull to much current it will just pop the...
Cameo and stepside use the same kit. I'm using maple on my 59 because I have it left over from a hardwood fo loor job.
Had a 364 nailhead in my 50 with a t 10 4 speed. Fun for sure.
Thank you and don't let your gaurd down. Let us know what you need there and post a address.
Separate names with a comma.
The Jalopy Journal
