The Jalopy Journal
The transmission in an open drive #78 case. Next to the spring hook on the throwout bearing collar is a threaded hole that I assumed is for a...
What kind of grease should I use to grease the output shaft and throwout bearing? Should I fill the bearing with grease through the zerk after...
I sent Wilcap the stock one and he was going to match the balance. David
I should be recieving a new flywheel from Wilcap in a couple of day to finish adapting an early Ford trans to a 394 olds and need to know the...
Thank You Everyone!
I just bought this body. The previous owner thinks it is a Dodge Bros body? Thank You for the help, David
Caffeine, This should be an easy swap if there is enough room for the increased length of a dual master cylinder. Post a picture if you can. I...
Did you tie one end of the damper to the frame? David
My friend who is a welder by trade, welds and cuts on tanks by purging them with argon David
Starrett Bi-Metal, and match teeth/inch to material The cheapest solution in the long run is to buy a bulk reel and a band welder with a...
For the 1964 394 I am using in my project, I used the center mount located under the damper and made some rear motor mounts that pick up some...
Is it best to run brake lines when doing inital mockup or wait until final assembly? David
I'd be willing to help. I am not an electrician, but have helped many people run power out to garages and home remodeling. Where in NJ are you?...
Has a 6 hp Tecumseh
Yes, especially since the doors are rougher than the body. My plan is to get it on the road and then make the decision. David
Yes, I bought the adapter from Wilcap.
HAMB, Here are some pictures of my first Rod. As with most beginners, I really didn't have a plan when I started and did most of what you see...
HAMB, My name is David and I am from Succasunna NJ (Morris County). I've been viewing this board for a few months and absolutely love it. I went...
I have an original 1932 Ford 1 input/output radiator I would like to use in a rod I am building to cool an Olds 394. Does anyone have any tips on...
Separate names with a comma.
The Jalopy Journal
