The Jalopy Journal
They put in a taller tunnel front to back I will get a picture tomorrow
Engine compartment just about finished rewiring
Made a little progress this week under hood almost completely rewired, fenders, and radiator back on. Waiting on a big delivery from Shoebox...
Ok my car has been converted to 12v by the previous owner half the wiring was pulled out but never redone. I ordered the voltage reducer for the...
My stand it what broke so unless I buy a new stand I'll have to use a block off plate thank you again for your wealth of knowledge
Question, do you cut it down to just below the block off plate so it can't jump out?
Yes everything on the engine is stock and the transmission mount seems fine too but the fuel pump hits the firewall stiff enough to break the...
That's perfect... I really appreciate that information I had read it was not completely necessary but definitely needed to hear for someone more...
I appreciate that information, that copper nickel ain't cheap lol but it is resilient
Slowly coming together ran into more small problems. The fuel pump stand broke because it was pinned against the firewall, its like it does not...
Also the fuel lines from front to rear need replaced, can anyone tell me what is the proper size line to use from tank to pump, I plan to use...
Hey I appreciate the info...
The stand is what broke but my original intention was to replace the pump as well as this vehicle has not run in quite some time so I'm replacing...
I could but from all the reading it's seems most think it's better to go with an electric fuel pump. Do you disagree? I am definitely looking for...
Ok so I was not intending to convert to an electric fuel pump on my 50 Ford custom but in moving the motor and getting it back in the frame the...
That is beautiful
It was someone's unfinished project, I got it in trade for some work I did. Original like factory which I know is a hard thing with all that's...
That's what I'm doing is going to get the engine running before I put it all back together just in case it has to come back out. I just got the...
The door handles and fuel door have sheet metal welded i I don't see a lot of bondo, the bullnose for the filler neck is still inside the trunk...
[ATTACH]
As soon as I figure out how lmao
It's still in pieces at the moment but I think I have ine
Thank you for the information it really is much appreciated
There is a scrap yard in Buffalo?
Where do you search for parts like scrapyards around here
Camdenton
I didn't think of that great advice I'll do that
I will get some ASAP and post them
Thank you for the input, yes I'd like to keep it as original as I can beyond what has already been done.
It's not that I can't figure out seat brackets or a filler door I was asking more experienced people for some cleaner ideas to keep it close to...
Separate names with a comma.
The Jalopy Journal
