The Jalopy Journal
You will see it on mine hopefully by this summer!
Sorry for the poor quality pic. Anyways, I now feel a lot better knowing that with some adjustments to the motor mounts height and position, my...
So after I mounted my motor last, I realized quickly that due to a large seam I would need to cut my floor and then fab up a new trans tunnel......
Man I could day dream for days going through this post!
Yeah post em up!
Very cool post. Thanks for sharing all the pics!
Coming along very nice! Chop turned out great!
Great post! I have a daughter on the way and hope she loves cars half as much as I do!
Cool post!
If that's a bullet hole those are a really cool find!
Cant wait to see it!
What part of so cal are you from? The Caddy Kings seem to have a lot of cars around the same vintage as yours... Unfortunately no cruises for me...
Great build!
Yeah I noticed that you did that on yours and it turned out nice! I have plans to modify the engine compartment pretty extensively, but step one...
Also got the engine mounted but may either need to cut into the trans well in the floor or cut and lower the mounts, or both. Going to take some...
Minor progress but lots of effort. I must have 5 hours into the valve and relay harness since we thought it was done. Some reading lead me to...
I unbolted everything and rotated while using a pry bar and no luck. After 20 mins, I just said screw it and gave the buyer of my engine the trans...
Great collection of photos!
Very cool pic!
I have a buddy looking to do a 41 as well. Don't think we're going to go that low though. As for the law, I think in Cali you cant have obstructed...
Welcome! you will find all the help and knowledge you need here... So if you need anything, just ask!
Just might need this... Thanks!
I like the way you did this firewall... Nice work!
Make sure you post pics so I can check it out!
Had a one shoot down a hole in the thigh of my jeans an caught the top of my inner pocket lining on fire. I didn't notice right away because I had...
I ran out of light so I couldn't finish the last two pieces of trunk. Here is where I left off. Obviously didn't get to the engine mounts either....
It's not as pretty with still some evidence of grind and cut marks out of it, but will get the job done. [IMG]
Three perfectly good wasted hours of daylight and prime fab time later, I stripped, cut, ground, re-welded, and re-painted the piece. [IMG]
I got to work on building a frame to hold the trunk floor and mount the EFI gas tank to. I thought that since I had everything pre cut at the...
My goals were to get new motor mounts installed, build out trunk, install new EFI gas tank, and fab mount for air bag valves and relays. That's...
Separate names with a comma.
The Jalopy Journal
