The Jalopy Journal
a 340/360 la. gear should fit right in
the best one to use would be out of a 70 to 81 z-28 or trans am they had the fastest ratio i think 15/1
I gess i broke the rule's by using a chevy water pump. Not to mention the pontiac rod bearings , the olds rod bolts and chevy valves and wrist pins.
i'm going sat. to check it out
kinda a neet old speedster,who know's it might follow me home.
Here's something to think about, I had a steel 32 roadster body and a glass 32 roadster body in the shop at the same time.I didn't weigh them but...
. Is this considered traditional? Hell yes its a hot rod Its about being creative, different , Making it slicker tricker and faster ,doing the...
10 ga. will be fine
is it a beam or a tube axle
on my 406 the edelbrock 750 went 12.71@113 the holly 3310 750 went 12.93@108 the holly has a better idle than the edelbrock. try them both if...
i'd think about useing copper tubing for the run to the rear, the extra heat dissapation will help some. the rad don't care were it's mounted as...
http://www.gnetworks.com/v4files/barrygrant/Ign%20timingwithimages.pdf
I'll bet on a year tops,:D Anyway great its almost ready for the road, and in 7 months . The first drive after a build or a major change has an...
the marine motors have 4-bolt blocks, most likely a steel crank, some even had forged pistons, the heads might have 3/8's stem sodium filled ex...
I have the motor out now, mabe i'll slide the 392 in and take some measurements
it fits without alot of set back, lots of room for a blower drive,but its a 315 dodge. anyway my 392 with donovan rocker covers is 31'' at the...
Will I watch yes will i be a fan i don't know.
conduit to protect the wire's also stainless studs welded to the frame for the grounds. i've also heard some bs that the dot is pushing for...
time trials 5:00 racing at 7:30
the unkown bad ass super's 1800# 468cid 70% left side weight and the best part most are home built...
The S-10 T-5 is the one you want, You could z the center of the x - member back and keep the pedal mounts in the stock location,
The tanks were front mounted for the fuel injection system,the fuel pumps can be a SOB to get primed if the lines are too long or below the pump
they do make an aluminum grinding disk , i picked up a few at my local welding supply. they work fairly well alltho they really make a ton of dust
back in the day narrow slicks hard rubber compounds ,racers did anything they could to get more weight on the rear tires
stack the cutters with spacers between them on the horizontal shaft
Well for one the merc's were to damm heavy to be considered as gasser materal
I switched my f-150 to dot-5 , i just blead the system 3 times to get all the dot-3 out ,no issues at all.The seal swelling issues i've run into...
I ran one on a 301 Chevy w/ 660's ,it needed a big accelerator pump shot, also had to stagger the jets (4 different ones) to get all the plugs the...
here's the link http://www.kustomsofamerica.com/northernrodkustomnat.html
http://www.speedwaymotors.com/p/2666,771_Tel-Tac-Tachometers.html this is the tack my friend uses in his sprint car
Separate names with a comma.
The Jalopy Journal
