The Jalopy Journal
You should get the factory spec pinion angle then set it with some angled shims. It does look low. You should have checked the ride height before...
@MP&C Whatever you do. Please do not cut that dash. Thay are a bear to patch once butchered and if you must have tunes put it in the glove...
Yea. There is usually something that needs added to the evil bay parts. More work cutting fitting and grinding back the welds but the major part...
They started on the street drag race show. Then had their own for a year or so. I do not remember the names of the shows.
^^^^^The video says Farm Truck and Asian. Two guys from a TV show.
I have used them before.:) Not all that bad. A little nip and tuck snipping, some hammering. It will be good.:)
Decisions, decisions. Aint it nice to have spares? Reminds me of my OT '66 Impala. Came with a 235 six, three on the tree. Swapped to a floor...
@VANDENPLAS I do this for him. DODGE.
@silent rick So sorry to post a like on your post above but. We all have our own pains to deal with. Yours appears to be extreme and I feel for...
On an International 706 diesel tractor. An unscrupulous dealer sold my FIL that tractor with harness leather replacing a bad bearing. When he...
Any way to repair the cover? What material is it made of, aluminum, cast pot metal, whatever? Could attempt Tig if aluminum or Muggy Weld if cast...
Did you already buy it, take it home, then find the crack? Best to open them up, and take a good look before plunking down the green.
Good to hear that. I didn't want you going in blind and getting hurt. You are well aware those compressed coil springs contain a lot of stored energy.
1 and 3 if you have the top one removed. DO NOT unbolt the ball joint without a spring compressor or a floor jack supporting the lower a frame....
Yup. You done it good and broke the input shaft.:D No clutch dumping?:rolleyes: For $150 it would not hurt to freshen it up but for occasional...
Check the HAMB O DEX. Transporters there that may be able to help with some spare room.
Another lesson learned grasshopper.:( Hot roddin aint cheap.:D
Still have it?
Add a little acetone or similar so it will help it soak past the blockage and free things up.
Then try the thicker oil first. If that does it for a few hundred miles a year OK. If not then drop the pan and new bearings. Price of the...
I didn't do it. :D
Definitely a rod knock.:( Don't worry your hair will grow back.;) Maybe.:eek: Definitely change all of the rod bearings while you are in there and...
Very possibly the spring in your cheap chinese fuel pump. try listening to it with screwdriver or tubing.
Not familiar with these cars but from the appearance the hinges may be sprung from the broken, missing door check stop. you could remove the door...
It is being used on a drum front drum rear vehicle. '65 F 100 upgrading from a single pot.
The back reservoir has a larger output fitting so that was my guess. Line is not bigger, 5/16th line but takes a larger fitting.
With the master cylinder shown upgrading from a single port to this double which would be the front brakes and which the rear? I have the required...
I never used exhaust manifold gaskets on my 60's Shivrola and Ford engines with manifolds and never had an exhaust leak. Headers, yes. Manifolds, no.
^^^^^^^^Correct. Even though they sell them in a lot of different gasket sets they are not needed.
What I said in post 2592.;) Remember what else I said Grasshopper. Learn. Continue learning. Never give up. Remember your mistakes and learn...
Separate names with a comma.
The Jalopy Journal
