The Jalopy Journal
I would say you have a master cylinder with two different bore diameters. The larger bore going to the front calipers. That would be the back line...
Probably just like everywhere else.... Quantity NOT quality.
A New F150
That'll rub right out! LOL
Good Luck! Hope it turns out well....
Just make sure all the flux from the brazing is cleaned off...
Ok, my turn. 1973, and I'm 16. Owned a 69 RS-SS Camaro. The starter went on the fritz so I got it up on the curb on the passenger side and...
It s ben a few years. Originally they threw a it because the number on the motor didn't match the title. I'll tell him to try again, thanks.
I know a guy here in Illinois who bought a 37 Plymouth "stock" not running. He went to get the title changed and they found out it has a 38...
Check your ground cable on both ends.
Lock Tite make a hydraulic thread locker that works good if you have no other luck.
You could start with1 1/2 tubing and add a 1/16 shim when done.
Oreillys should have a book with the poundage in it.
I have a buddy's 39 windshield frame. He took his car to a glass company to have them butt the windshield and glue in. They took the frame out,...
Sounds like a header leak taking off to me.
Rulers are called Shrink rules. I have several that I no longer use. I worked in a pattern shop for 35 years. Most of our work went by 1/8" shrink...
I don't see any difference in a Brookville or Fiberglass. They are BOTH reproduction. Not everyone has access to an ORIGINAL 32. Ford didn't...
You can melt aluminum with Good charcoal if you hav an air source blowing in the bottom. Know a guy that buried a 5 gallon bucket in his back...
I use Mertons Fiberglass and Marine. They have a good selection.
Here's a still of one corner.[ATTACH]
this is a firewall I'm doing for a 56 Ford pickup.[ATTACH]
I was always taught if you weld all the way around a shaft, it will break beside the weld. I would sleeve it and pin both sides after welding it,...
Orielly's rent a thread restore set.
This is a glass dash I laid up for a 1997 Chevy truck[ATTACH]
Ours is glass. Been driving it since 2005 and not one spot of rust.... Just drive it and don't worry about the rest. I didn't build it to make...
Wheel bearing too snug? Not allowing piston to be pushed back in caliper.
Seems like they all fall apart sooner or later. I've had cheap ones and expensive ones and they all eventually fall apart.
Outlaws "T"s Nauvoo,Il. 217-453-2359.
[ATTACH] [ATTACH]
It's all about the money anymore. The cheaper they can buy it, the more profit they make.
Separate names with a comma.
The Jalopy Journal
