The Jalopy Journal
Chasing a valve train tick on a customer's small block powered 32. While running the engine with the valve covers off it's definitely [ATTACH]...
Long story short I swapped out my trans with one that I had rebuilt because of some problems and a vibration. Tore apart the trans this morning...
As the title states, I'm looking for somebody to balance A Flathead flywheel and clutch assembly in the so cal area. My shop is in Lancaster and I...
I've got a 1963[ATTACH] [ATTACH] chrysler newport here at the shop that I actually used to own twelve years ago. The new owner drove it for a few...
I haven't driven my 64 el camino in a couple months cause i've been daily driving my 55 plymouth or 41 ford. Local lady wanted me to look through...
Going to Viva Las Vegas on Friday. Should Do a once over on the car. 1955 Plymouth Belvedere, with the 241 Poly V8 and dual point...
I can't find the exact thread size for the champion UY6. Says it's 10 mm, but doesn't give the pitch and when I measure it, it Doesn't seem right....
I've got a customer's car here That's a stock 46 Chevrolet Fleetmaster that whines in third gear. I've got the transmission cover off the floor...
Got a customer's car here with an 8bA That was recently had some work done at h and h flatheads For a bad crank. They did the work and it turned...
I need some help with a 6 V tail light bulb. Right now I am using a 1154 which is a 6 V dual filament. But the glass itself is too large. I need a...
I noticed on the rear of my 55 Plymouth. The brake shoes we're only contacting the drum on the top one inch or so of the shoe. Made me think that...
On my 64 el camino the power steering pump And box Have been leaking for a very long time. I bought A new steering box and pump from opgi. The box...
Was doing some paperwork when some trash blew in my shop and I could see It was some pictures or something. Picked it up and it was a piece of...
Friend gave me a bucket of early ford trans parts.said it had some zephyr gears so I was interested. No zephyr gears and all surface rusted.worth...
In my 55 Plymouth, I hooked up the heater core as it was getting cold out and it only lasted about a day and a 1/2 before it went out. The only...
I've got a vibration in my forty one ford. It's got a rebuilt 8cm mercury flathead And the stock rebuilt transmission and old stock rearend. New...
Was low on oil in the 55 plymouth and all I had at the house was some old metal cans from way back when.2 out of the 3 were nice and clean,quaker...
Open drive, banjo parts for free. You pay [ATTACH] shipping what you see is what you get. (Shipping pending 3 people in line.)
I've got a steering box from a friend that wanted me to rebuild it and said it was out of A52 Chevy car, but it appears to be out of a later 53 or...
I've got a Chevrolet small block 350 here at the shop that is bored thirty thousands over and only has a few 1000 miles on it. Whoever put the...
customer states flathead is leaking ALOT. So it is leaking badly out of the rear main seal area.I pulled the motor and found that the rear main...
On my 55 Plymouth, with the 241 Poly motor I've had an oil leak coming from the fuel pump and finally pulled it off To find that there is a weap...
I'm looking to buy a dwell meter Is that is just that. Dwell and rpm. I like the old style ones with the needle. And I've bought a couple but...
I got a customer with a 56 Cadillac That needs some third member parts and was wondering if a 57 would interchange? I know that the yoke is...
Everybody knows that the heat and the new gas sucks. About halfway home The car is running warm and it starts cutting out And I have to flip the...
I've got a new set of vintique. 32 Ford rear frame covers that were never used 150 shipped Bri[ATTACH] [ATTACH] an 6618780676.
I've got a brand new brake booster Conversion kit with the master cylinder, booster, brackets, and proportioning valve for a 1959 to 1962 Cadillac...
I was thinking of putting some lake pipes on my 55 Plymouth and happened to have a used one that is 70 inches and a little short, but I can buy an...
I've got a customer's 66 Chevelle Here with a leaking axle seal and cannot identify who made these c clip eliminators. The part number on the seal...
I've got a customer that had moved to East Las Vegas a little while ago. And she's having a problem with some electrical And she says that her...
Separate names with a comma.
The Jalopy Journal
