The Jalopy Journal
Took this out of the 35 I had. Side glass is nice. Windshield is a tad smaller than original but it had a rubber trim that allowed it to fit and...
I put a new carb on so I rebuilt this and put it in the box the new one came in. I never ran it so it will need to be adjusted for your...
Door glass and a windshield. The windshield was a little smaller than original but fit the frame with a different rubber trim (Included). Glass...
I'm not sure if this is normal behavior or not. When I am in a thread and I click "Top" at the bottom corner of the page it takes me out and back...
Ok it was suggested I use Permatex rather than the rubber seals that came with my intake set. Well the auto parts store had several to choose...
I'm putting new gaskets on my intake and the gaskets do not have the holes for the heat exchange. It is blocked off on my intake on the top but...
I ordered enough whisker strips to do inside and outside on the doors and back windows of my Fleetline. Is there a different rubber type seal that...
I am replacing the rubber seals on my 50 Fleetline Deluxe. I started with the back glass. Put the new rubber around the glass as instructed and...
Hey guys, I started having trouble with the carburetor on a car I recently picked up and I have no plans to rebuild it at this time. I want to...
Hey guys, I am changing out the springs on my Fleetline and have tack welded the spring perches on. I'm not good enough to do my own welds for...
SOLD
What's it sound like? I have a tall shifter on my car and I am getting a clacking noise at low speeds 1-10 MPH. It sounds like a parking pawl or a...
I just rebuilt the front end on my 50 Fleetline. It was not too bad for a first time! Waiting on the idler arm to come back from The Filling...
I am trying to install the upper inner shafts into the cross member of a 1950 Chevy. I got one side through and push it to the other side. (front...
Please delete
Does anyone know what this tool is? [ATTACH] Posted using the Full Custom H.A.M.B. App!
Does anyone know what this tool is? [ATTACH] [ATTACH] Posted using the Full Custom H.A.M.B. App!
Just picked up a 50 Fleetline and the gas tank started leaking when I put gas in it. Ends up having a aftermarket tank (plastic) and the outlet...
Hey guys ... I have a Carter WCFB I am trying to ID (numbers to reference for ordering parts) and is this a good size carb for my engine. I would...
No longer looking ... thanks for the replies! I am looking at a car in Sarnia, Ontario CA right across from Port Huron Michigan 1 hr East of...
[IMG] I just posted this at the Ford Barn and I thought it may help someone here too ...... I have not been a member long, but I have already...
I'm getting ready to install the windshield in my truck. Does the setting tape get folded over the edge so both sides are sealed or does it just...
This column and wheel are grafted onto my 35 Ford. I have not identified the steering box yet but I would like to ID the column and wheel. The...
Is the cable end attached to the gage removable or permanent? I don't want to mess it up. I want to reroute the cable and this end would use a...
OK just spent an hour in NAPA and left empty handed.... How do you order a brake hose without a vehicle to associate it with. My hose is on my...
SO .... when I got my truck the headlight high beams did not work. I looked at the dimmer and the center pin was broke off and one of the other...
Does anyone know what these REAR fenders are off of? Thanks! [IMG] [IMG]
Separate names with a comma.
The Jalopy Journal
