The Jalopy Journal
We have installed a Gen II Mini, 66005-VUX-A, behind the seat of a 1933 Ford three window coupe. Controls are 4 knob, Gen II Streamilne Panel,...
I am considering putting "Big and littles" on my Studebaker chassis because of Studebaker's strong performance heritage. In bench racing with my...
Where is the best location for flex joints for a set of side pipes. My side pipes have silicone bushings for mounts, but are semi rigid....
Has anyone used an Opel Gt steering rack? It looks about the right length for my Studebaker. I'm curious if it is adequate strength wise, as my...
I have need of a source for the single female connector with two terminals that mates with the two prong brake switch from GM from the 60's...
Several people have already installed hydroboost on their brakes. Perhaps someone has already encountered this. I need an adjustable pushrod...
Since installing my motor, I no longer have room for a vacuum brake booster, and am going to install a hydroboost. I was looking at the Bendix...
I understand that the inner tie rods on a rack and pinion should intersect with the line between the upper and lower A-arm pivots. To fit my...
I'm helping a friend with an Autometer volt gauge that is reading inaccurately, it is several volts off. It has been off since he received the...
I just installed some headers, and they are extremely close to the fiberglass body. Is there a rule of thumb how close headers can be to...
Who sells the color coded wire for wiring your car without the fuse block? I like the idea of having the wire marked with the description every...
I am using some 1 1/2" stainless tubing for water hoses to the radiator. I am using regular radiator hose to adapt this tubing to the water pump...
I'm assembling the radiator hoses right now, by splicing different hose ends to common tubes. What can I use to lubricate the inside of the...
I'm installing a wiring harness on what I have been told is a Cleveland 351 in '29 short bed truck. I've only delt with small block Chevies in...
I'm planning on installing the battery flush with the bottom of the frame, under the rear seat foor pan, on one of the rear legs of the central...
Have had some trouble bleeding the brakes on the '32 we are working on. Decided to take off the master cylinder to check it. It is an 1 1/8...
I picked up some 7/16 and 3/8 torque converter bolts for a 32 Ford we are building. With the 350 Chevy were are using a 350 turbo transmission....
We have a 32 Ford under construction. We have moved the rear end back to visually center it in the rear fenders. Previously we moved the motor...
How large is the temperature gradient across a small block chevy with cast iron heads? The reason I ask, we are using an aluminum air gap intake,...
I'm thinking about using the Cole Hersee latching solenoid for my battery disconect, so I can remote mount it. Part number 24200. Here is some...
Does anyone make a headlight bucket for a sealed beam where the two alignment adjustment screws are accessed from the back side? If that is not...
Looking for a headlight trim ring smaller than 9" OD. [IMG] This is a 1949-54 Chevy truck ring about 9" in diameter, need something in a...
We are using a Walker radiator in a 32 Ford, with a small block Chevy. Does anyone have part numbers for the radiator hoses that we can adapt to...
Does anyone know of a catalog, chart, or listings of dimensions for replacement disc brake rotors? Rather than go the route of rotor hats and...
In contacting various rack and pinion rebuild manufacturers, there are supposedly no other front steer racks that are substantially shorter than...
New to the forum, so I apologize if this is a silly question. We are making a stainless steel chassis for a Studebaker Avanti. We have narrowed...
Separate names with a comma.
The Jalopy Journal