The Jalopy Journal
The heads and block deck on my 303 Olds were milled slightly at the machine shop to true them up. I also have a new hydraulic cam from Ross Racing...
I have a few questions on assembling a 303 Olds. When installing the two oil galley plugs on either side of the cam at the front of the block, do...
I'm starting on my 303 Olds engine assembly and I need to decide which type of rear main seal to use. I have both the rope and rubber seals from...
I have a 1949 303 Olds motor that I am building for my 32 deuce coupe project. I was able to get a pair of 1954 #7 cylinder heads for it to...
Does anyone have a 1955 Olds #8 cylinder head that they can measure to give me the dimensions of the intake ports from ( Height and Width). I have...
I have a 1949 303 Olds motor that came with the original 6 volt starter. I will be wiring my project car for 12 volt. I understand that the 6 volt...
Found this video on You-Tube. Interesting test setup, what do you guys think. [MEDIA]
I'm considering using a Pertronix ignition module in my 1949 303 Olds motor. I have a later model distributor (#1110824 3L4) from a 1954 324...
I am looking at using three Stromberg 97 carbs on an Edelbrock 396 intake on a 303 Oldsmobile. I will be using a progressive linkage where the...
I ran into a problem with clearance for the fuel supply and return lines at the gas tank on my 32 Ford coupe project. I have a Brookville coupe...
I got the gas tank installed in a chassis from Brookville Roadster. I'll be making my own rear spreader bar so I used a scrap piece of 2" dia....
I'm working on installing a Winters quick change rear in a Brookville 32 coupe frame. I'm using coil over shocks and ladder bars. I set the frame...
I'm getting ready to finish up on the front end install on my Brookville coupe project. I need to know how to locate the rear mounts on the radius...
I need advice from anyone familiar with putting a 303 Olds motor in a 32 Ford 3 window coupe. Here is the motor with an adapter from Ross Racing...
We've all been watching Flop's threads on how a master metalworker chops a 32 three window coupe, this thread will show how an amateur learns how...
I have a 303 Olds that has a Speed Gems pilot bearing adapter in the crankshaft. I bought a trans adapter from Ross Racing to mount a T5...
Picked up a Brookville coupe and frame at Fall Carlisle and ordered a flat firewall for it. I understand that the body was lowered over the...
I have a Sun Super Tach Model SST-802-2 that I can't get to work. It blows the fuse on whichever circuit that the 12 volt ignition terminal is...
I have a 55 Chevy with a 57 Olds rear in it. I ordered a drive shaft for it that comes with 1350 U-joints. What conversion U-joint do I need to...
Hello everyone, time for me to introduce myself. First I would like to thank everyone for sharing all their great info on this site. I've found...
Separate names with a comma.
The Jalopy Journal