The Jalopy Journal
It’s been a few years for me, but that square hole bracket doesn’t go on the brake end it’s the other end. The cable end with the ball fits in the...
Found out the previous owner bought it from a guy with multiple hot rods, from Ellington Conn. Edited title to reflect that.
I kinda figured it was a long shot, but I’d give it a try . All good ideas above. Which got me thinking, I might have the guys name or address...
[ATTACH] Yea I've been going to do a thank you to the hamb post. Its my first early Ford hot rod build, I faithfully read all the T builds and...
[ATTACH] Sorry, how it looks now. Still some work to be done including paint.
[ATTACH] I bought this '27 T body out of Connecticut about 8 years ago. Saved it from being a RR and put it on an A frame with a 241 Hemi. Now...
Maybe you have it figured out already. I don’t usually check this part of the forum, saw it and forgot to get pictures until today. When you pull...
One I built, copied from a picture I saw somewhere.[ATTACH]
Try Roberts motor parts or Andy Bernbaum for Heater shut off valve. Did someone switch the oil pan?
Sorry for your loss. I lost my Dad 9 days ago. It's been rough.
If I remember correctly, at some point, possibly when they went from B series to C series trucks the oil pans went from rear sump to front sump....
[ATTACH] [ATTACH] This is a '47 truck block in my '56 but I think it would be the same.
[ATTACH] Nice Job! I did single stripes with a makeshift guide and found it difficult to match up at the start finish. Yours look great.
[ATTACH]
I don't know if this helps because this is a 241 , but there is no hole in this block at that location. If nothing else I'll get you back to the...
I seldom use it and definitely don't have a full grasp on the use of it but, it has all of the scales labeled and directions on the back. [ATTACH]...
If this is any help , I did a search on Timken's website L68149 comes up with a 1.3775" id.
1.The truck bellhousing will bolt to the Plaza engine 2. The truck flywheel will bolt up as there are 4,6,and 8 bolt patterns, but they...
Ahh.. you are correct my mistake.
Dodge Truck VIN Decoder at http://t137.com/registry/help/decode.php says its from a 1961-62 M37B1
If I remember correctly the starter drive retracts when the engine starts and spins it faster, so on the bench the drive pops out but doesn't...
If it's a 70's truck rear, which it sounds like, you also have to watch the diameter of the axle where you want to shorten it to. They are a...
If I remember correctly, there is a spring in the latch mechanism that breaks, causing the issue. It's a clock type spring. Good luck trying to...
I like'em too. Painted a set of these up for my '27 T build.[ATTACH]
Yea I do, not sure what it came out of . The shift mechanism was somewhat unique. I didn't use any of it, the original truck linkage and shift...
I've got a '56 Dodge with a 230 and overdrive. With 3.50's in the rear it was okay on the flat but dogged pretty quickly on a grade. I switched to...
The general forum here will get you more information than being in the traditional hotrod forum, and P15-D24.com has a forum dedicated...
I agree looks like a mid 50's Dodge replacement engine. Measure bore and stroke as stated already. Check the head length 23 or 25 inches. The US...
The P15-D24 forum has this manual as well as others available for download. See if this link works for you....
Separate names with a comma.
The Jalopy Journal
