The Jalopy Journal
Bad deal. Hope it ends well. I will say those thieving ass bags do have fine taste in cars though.
Just went out and checked.Top a frame bumper is about 2" above the frame.Lower bumper not so much on mine, about 1" below. I did however remove...
Are you running a powerful electric fan?Maybe pulling a good bit of amps on its own,then with the headlamps might be asking to much from your...
Yeah, Im thinking a little experimental bending of the sender arm may be required to get a better reading.Also,with those runtz reducers,you can...
I have recently used this same set up on my 49.With my 20 gallon 65 mustang tank and sender,a full tank registers all the way to the right on the...
That ones gonna be a lot of fun.
You have to cut the firewall.
Boss Hog would be so proud.My sister had a '69 with a 472 that would smoke the tires till you wanted to stop.You could hit passing gear at 100.
One problem I have run into putting a sbf in a Model A is fitting the lower radiator hose around a good sized fan like yours.Seems the fan blades...
These Ford fans should be wired up using at least 10ga wire and the proper rated circuit breaker,relay,and switch.They pull some good amps on...
Bottom line,I like driving hot rods that you don't have to worry about overheating.
Early 90s Taurus works well for me.Cheap,dependable and easy to fit.Its a two speed fan,I only use the low speed with a 40 amp relay turned on by...
Find a early '80s Monte Carlo preferably the SS and cut the front end out.You can do this swap with all new bushings,tie rods and ball joints for...
I ran my BBC powered A coupe over there that same weekend and found traction to be the limiting factor every pass.Turned an 8.1 at 93 easing out...
I just put a s-10 clip on my '49 Ford coupe.Fits real nice but I would agree with heavy that a G body is right on for track width.The s-10 is a...
Mostly rolling Halloween decorations with all the spider webs and rubber rats and what not.
If your're really wanting to know,pop the intake and look at the lifter valley.It will say 289 or 302.The heads will also tell you if you pull the...
My dad had a '55 Crown Vic when I was a kid in the early '80s.Old paint and rust with a set of Keystones on it.I thought it was cool to ride...
'31 A coupe,489 bbc th400 9", hoop with two down bars.2750# with a tank of fuel and me outside.
If your rear is out of a Ford truck check the inner diameter of the seal,where it rides on the axle.There are two different sizes depending on...
Milners coupe for me.That '55 was just a field car.
I'll be there with my A coupe.
With a full house uncorked Hemi up front,I would'nt worry about it too much.
It takes a lot of work to get old worn out paint to look nice and shiny.I imagine it takes some work to make nice shiny paint look worn out.As a...
I've always enjoyed the build.There's nothing like putting so much thought and work into your project,even when you know that most people that see...
Little kids and real old timers always say "cool" with their thumbs up.Everyone in between either wants to tell how much they know or say...
Man,that's a testament for being built to last huh?As cool as that is,I'd have a hard time keeping the torch and the big hammer away from her.
I have the original gauge panel in my '31 A Coupe.The original speedo and fuel level gauge are still there for looks.If you slightly enlarge the...
Nice choice for power.
Henry would be proud.
Separate names with a comma.