The Jalopy Journal
make sure its s deep bore master for manual brakes good luck , fighting similar issue, just changed front pads turned rotors and change the...
the one inch bore MC should be right for drum disc , calipers in the right position , lines are in correct position wheel bearings checked and...
the hand brake works and the rears have been adjusted, will pull the pads and see what they look like, rear shoes were good not much wear and no...
Sorry. left out manual brakes, under the floor, brakes are 11 inch ford bronco rear end 9 inch, fronts are 5 1/2 pin ? not sure the car isn't here...
I am looking for a little advice. I have a 32 ford highboy, chevy powered etc, gm single piston disc brakes up front with big ford 11.25 drums in...
31Vicky thanks for the info, Summit didn't carry that part when I needed it but glad they do now. I am getting the 3.75 turns and the 6 inches of...
Chris, the front wheels are 15x6 I forget the offset, pretty much even, the tires now are 195x60x15 replacing the 50 series in the avatar. Got...
Wizzard, you are correct that rack is not set up correctly, should be 3 3/4 turns lock to lock. Mine is a dream on the highway, around town no...
I have checked several sites, including HAMB, re Unisteer and using a Jeep Tie Rod end to shorten the turning radius. This is the only...
Not sure this helps but a pump shaft from a 283 sbc is not the same length as one for a 327 sbc.....its been awhile but the 283 is a bit longer...
Had the usual sbc problem with hot start, headers too close to the starter, multiple gm starters, adding a heat shield never worked for me,...
Check out Ebay, under wind wings, Lucky brand about 65.00, clear, prebent and mount using the windshield studs. Bought a set a few months ago ,...
While I agree that there are good and bad people in every occupation, did you ever think that he was just trying to tell you that the light was...
I know this is an old thread but I had a question about my Bop Top and called Sid for advice. Could not of been more helpful, gave advice over...
thanks for sharing a little bit of everything for everyone....nice work
if you want to be period correct and legal with the corvair you will need a commercial plate. Keep in mind that the plates were issued in order...
For those of you who don't have access to a lot of tools, use black electrical tape in the area you want to cut. Take an adjustable style hose...
Long ago I ran a B/MP 57 Chevrolet as a teenager and the weak point was always the rear end. After one race I blew the posi unit and sheared off...
Just short intro, been lurking for awhile and learning some good stuff. I have mostly owned and worked on 50's and 60's Chevs but recently bought...
Separate names with a comma.
The Jalopy Journal