The Jalopy Journal
First Rate !!
mohr hp-Well said !!
Excellent pics & coverage-Love it!!
I have a 1940 Ford with a Chevy engine. It has a Walker radiator with a 90 degree lower connection which is fabricated so it leans back towards...
What were those tapped together pieces used for on the table?
Manley makes a pushrod length checking tool for a variety of engines. Jeg's price for the Manley small block Chevy engine part no. 660-42132 is...
The green roadster pickup truck sure has some nice construction & details. It looks like it has seen some serious miles but everything is in order.
NAPA sold them years ago & should still be available.
I swapped the early 6 volt VW wiper assemblies for ones that were for 12 volt-1967 & up.
Perhaps EMS has changed their dies from back in 2001. My friends replaced the tail pan & the lower fit was beautiful. Unfortunately, in order for...
Is the master cylinder on the firewall or under the floor?
Here are some products I have run across BUT have not used: HOT ROD magazine article. A link to that product:...
Could your jetting still be too rich-causing the fouling?
The Lokar Neutral Safety Switch is a NAPA NS6581 or Borg Warner S395. Mine had electrical connections that were difficult to do under my car. I...
The configuration of the tubes will not conduct electricity evenly. This will give an uneven coverage of any electro plating. The net...
The way I understand the manufacturing of the parts you had to build a CAD file of each part & do an assembly of those files to ensure each piece...
When I was working on the WWPPS Nuclear site I attended one of the Washington state events. I was driving a '53 F100. I recall a truck whose...
I believe you are going to have to modify or change the oil pan so the pitman arm can be brought up. Messing with the drag link limit your wheels arc.
I do leatherwork during the winter & tooling leather to that detail shows real craftmanship. The Ford scrip & the staining is very nice touch.
Clutch & Brake Pedal Seals Part no. 91A-2476
Where did you get the reversed eye spring ?
You do not need to get another carburetor. Layout the dimensions of your existing throttle arm on a piece of paper & then incorporate the data...
Corndog-I'll see if my friend can get you his phone number. I was told he would be having lunch with him & others next week.
This HAMB thread link will take you to pictures of the sedan from Marietta, GA. I was told it is owned by Joe Hatfield. LINK:...
There is a '32 sedan in the Marietta, GA area that could be that car. He drove it to the the last Carolina 32 Run. He is a friend of Dick Wesson....
Install it so the pitman arm shaft is horizontal. Position the box so the pitman arm shaft is below the bottom of the frame. Make a bracket to...
What is the front suspension & steering ?? Was the firewall cut ?? Which 4 speed-Mopar or GM ?? Is the clutch linkage mechanical or hydraulic ??
The following dimensions are from the end of the spline to the backside of the flange-the surface where the studs are seated: Long axle 30"...
I love the flame job !!
I carefully use a pair of pliers on each segment folding that segment over the wire.
Separate names with a comma.
The Jalopy Journal
