The Jalopy Journal
Yes
http://www.kbspaints.com/ With what you say about your build I would use the KBS coatings for the cost and work. Can be brushed on and is a very...
Not much help here but did you call the Ididit tech, they might be some help.
[MEDIA]
http://www.lvvta.org.nz/documents/infosheets/LVVTA_Info_01-2013_Unsafe_Aftermarket_Steering_Columns.pdf...
Thanx it worked
I can't find it on E-Bay but than I am not any good at finding stuff there. So can you make it simple for me and post the address here Thanx
Try www.p-s-t.com
I believe this is a new product for them so would not be much actual use reports yet. I have the rust seal paint on my frame, been on for three...
Michelin makes a 235/70HR15
[ATTACH] [ATTACH] [ATTACH] As she sits, my 55 panel. 96 lincoln mark VIII rear, 1 1/4 rear sway by addco, 373 posi by fearless gear, 76 aspen...
To me there is three scenario's here, incorrect wiring (said it started a couple times so unlikely), bad ignition switch or bad starter solenoid....
Does anybody have any experience with the flat steel running board repro's out there for 575 a pair?
Sure will. This week-end I am going to the North-South annual run, this is a run involving the F-100 Pick-ups Limited club of southern ca and the...
Not planning on selling if I manufacture a set, not into that, just want a set for my project and am willing to manufacture. I can give you a long...
Thanx I really appreciate this. Have not contacted the ford truck website yet but will first thing tomorrow, and all tips are much appreciated.
Yes those are the ones. If I could get close up pictures I will make the attempt to make them. At this point I don't see me finding a pair to...
You just have them dismantle the whole car or you dismantle it and than buy each part separately. The dismantler has met the letter of law, made a...
Might want to weigh the total cost here.Shipping can drive the cost up
What I see here is a plenum inside a plenum. Get as much air around the intercooler to the radiator, cut off as much of that flange on the...
Is this an air to air inter-cooler or a air to liquid inter -cooler? Either way think dual plenum style. Are those blue 90 degree els 4" rd with...
Alot of places for the air to get lost in the current design. The intercooler mounts to the front side of wishbone I take it. Close the sides, bot...
Thanx,, that is the one crimp tool I don't have. Hopefully the OP has the crimping tools
Not hijacking the thread, but what I am going to ask might be pertinet to what the op will ask. HRP I just purchased the Highway 15 but did not...
Been looking for these for quite some time now. I have decided to make the attempt to manufactur some. If anybody owns one of these panels with...
If you move the radiator in front of the support make sure your hood clears the top of rad when closed On my sons 54 ford we just raised the...
[IMG] This was my first battery drill when I started in the trades. 1971
Probably would not have advised this if I had seen the pictures first. My advice after seeing the picture would be to find a different style of...
With no experience I would start with what you have listed but replace the bench grinder with a good 4 inch angle grinder. Than as my experience...
Separate names with a comma.
The Jalopy Journal
